cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
658
Views
0
Helpful
3
Replies

Catalyst 2960S switch stack support?

jgbright
Beginner
Beginner

I have a customer with a new stack of four Catalyst 2960S switches.

Is this configuration supported by Onplus?

I can't seem to figure out the login access and enable access credentials

so that Onplus can backup the configuration of the stack.

Jeff Bright

Bright Systems

Broken Arrow, OK

3 Replies 3

SHAWN EFTINK
Contributor
Contributor

I also have a 2960S stack in my office. I checked my handy OnPlus iPhone App and it shows backup, restore, and firmware all equal 1 which I recall correctly means backup is supported. I'll double check when I get into the office to ensure backups are actually working.

Sent from Cisco Technical Support iPhone App

Shawn Eftink CCNA/CCDA Please rate all helpful posts and mark correct answers to assist others searching for solutions in the community.

SHAWN EFTINK
Contributor
Contributor

I have checked and confirmed that the 2960S is supported.  Mine is backing up the configuration perfectly.

For future reference, here is the list of supported devices.

https://supportforums.cisco.com/docs/DOC-17501

Shawn Eftink CCNA/CCDA Please rate all helpful posts and mark correct answers to assist others searching for solutions in the community.

Yes, the device is supported, ensure that CDP is enabled and provide the access credentials under the credentials tab.

Thanks,

The OnPlus Team

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers