cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.

354
Views
0
Helpful
1
Replies
SHAWN EFTINK
Contributor

Feature Request and Feedback

It would be very helpful to have the ability to stage the OnPlus agents for deployment prior to arriving at a client site.  By that I mean it would be helpful to have the ability to statically assign all the IP information, since we have clients that only use static IPs for security reasons, as well as update the appliance before sending it out.  There are ways to work around this, but they are very tedious.

One piece of feedback on this is that OnPlus currently requires DHCP to Activate however it doesn't do a very good job of managing a DHCP environment wherein devices may regularly change IPs and OnPlus picks up and enters a duplicate device with the new IP and lists the old device as missing instead of merging/purging.  So deployment to these static environments will actually have less challenges after deployment despite the fact that deployment itself is a challenge.                  

Shawn Eftink CCNA/CCDA Please rate all helpful posts and mark correct answers to assist others searching for solutions in the community.
1 REPLY 1
aqkazi
Enthusiast

We've had this request from other partners also. I'll add this to our list and see if we can have this implemented.

Thanks,

The OnPlus Team