cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1391
Views
0
Helpful
3
Replies

NTOP and SPAN

curt-wwwww
Beginner
Beginner

I loaded NTOP on one of our customer accounts ... it loaded fine.

I had already connected the ON100 monitor port and was getting ready to configure the switch (Cisco 2960) for SPAN but noticed that NTOP was already reporting statistics ... it appears to be on the entire VLAN.

Question: Does the ON100/NTOP automatically trigger the SPAN destination port on the switch ... possibly because they are both Cisco products?

TIA

3 Replies 3

aqkazi
Enthusiast
Enthusiast

Hi Curt,

The ON100 does not trigger the destination port as a SPAN. NTOP will begin to analyze the data that is being provided, which may not be representative of the entire network. It could have been a trunk port.

Thanks,

The OnPlus Team

afullfor
Beginner
Beginner

I'm hoping what you are seeing is traffic outbound from the ON100.  If you go to IP/Traffic Directions you should see no received traffic for the paths with data.  Some of the active discovery protocols we use haven't been convinced to bind only to the eth0 interface.

We have an plan at some stage to annouce as a switch on CDP, which should automatically wake up trunking when the upstream supports SmartPorts.  That would simplify the multi-VLAN setup.  I don't think there is an option to request SPAN - that would be a security concern.

Andy

curt-wwwww
Beginner
Beginner

Thanks for the replies.  I configured SPAN and the reported results make more sense now.

One Problem: All relevant screens report data with the exception of: Summary->Network Load.  Is there a way to kick-start this?

(I have shutdown NTOP and also re-booted ON100)

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers