can we configure UDC to both SFP in 15454 M6?

[mohammed.samman1]

Dears,

can we configure one port UDC to both SFP in the same TNCE. so we can transmitt the UDC traffic to both side west and east.

the objective is, I have a DWDM ring . there is ASR903 router in each access site and i want to make out band management for routers through OSC. to do that i will connect Router RSP port  to the UDC  but there is only one RSP port available.if it is doable, I will connect ASR903 RSP to UDC and from UDC to both SFP (point to multipoint).

[kayukovvalera]

Hi,

Each UDC port associated ONLY to one particular port and you can't provision it to share traffic to both sides. Left UDC port associated to TNC in 1 slot and right UDC port associated to TNC in 8 slot. Connect both UDC ports to switch and provision UDC in both TNC cards. UCS do not support vlan tagging and do not forget to turn on STP protocols on management switches in ring.