cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1092
Views
0
Helpful
1
Replies
Beginner

CTC 9.5 and windows 8

I am trying to get CTC to work with windows 8. I keep getting an error mesage "Node is eitehr invalid or not reachable. Please verify and try again.

I am able to ping, telnet and tl1 into the node. I am able to http://x.x.x.x/fs/StartCTC.exe and download CTC

I downloaded and installed 1.6.0_21. I set it to enabled in control panel.

I ran

netsh interface tcp set global autotuninglevel=disabled

and verifed it is disabled.

TCP Global Parameters

----------------------------------------------

Receive-Side Scaling State          : enabled

Chimney Offload State               : disabled

NetDMA State                        : disabled

Direct Cache Access (DCA)           : disabled

Receive Window Auto-Tuning Level    : disabled

Add-On Congestion Control Provider  : none

ECN Capability                      : disabled

RFC 1323 Timestamps                 : disabled

Initial RTO                         : 3000

Receive Segment Coalescing State    : disabled

Is there anything else I can try?


					
				
			
			
				
			
			
				
			
			
			
			
			
			
		
Everyone's tags (4)
1 REPLY 1
Highlighted
Beginner

CTC 9.5 and windows 8

It turned out to be my internet  security software was blocking CTC. I added it to the all the exclusions and it still didn't work so I disabled it and it I was a able to CTC to nodes.

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here