cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

713
Views
0
Helpful
0
Replies
Highlighted
Beginner

Debugs for SFP or Network Module

Had an SFP quit transmitting today and throw low TX power messages.  I'm assuming it's a possibly faulty SFP or 10G Module, however I'm unable to find any useful debug commands to narrow that down.  Debug transceiver detail doesn't seem to be catching anything, and I can't find any debug command for modules.  I did set debugging on the interface to try and catch anything there, but I'm less than hopeful.

Are there any debug commands associated with SFPs or Network Modules (C3KX-NM-10G is the specific card)?