05-21-2015 08:53 AM
When I pass my 10Gb ethernet DWDM signals (from a cisco EWDM mux) into the com RX port of my OPT-AMP-17C the node is reporting "Incoming Payload Signal Absent" which doesn't make sense to me in an ethernet DWDM environment. This is a lab setup, so when I remove the AMP from the mix my two DWDM endpoints link up without issue. I'm seeing good input signal on my com RX port as well. What does LOS-P really mean in this context?
[DWDM optic] --- (EWDM MUX) - AMP - (EWDM MUX) --- [DWDM optic]
07-18-2015 07:25 AM
Josh, it would be better if you open a Cisco TAC case.
07-18-2015 03:27 PM
I solved the issue, I forgot to update. The LoS threshold was not set, so even though it had a signal it was still setting off the alarm. Once that parameter was set it started working.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: