ip over dcc, stack consists dcc, hdlc,ppp,clnp,ip

[vishnuvarmac]

hi all,

sdcc channels are the D1,D2,D3 bytes in the header part of the sdh. these channels are used for network management data. in dcc we use to hdlc or LapD/ppp protocol at data link layer and then ip protocol. ip is the logical address so what is the address format we can use at physical lavel in this stack.

thanks & regards,

vishnu

[ciscomoderator]

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.