Hello Guys
I have two 3850 with the same IOS version and the same transceivers model but only one shows me DOM and the other does not
Does anyone know what's going on here?
Sw1#sh int tenGigabitEthernet 1/1/4 transceiver detail
Diagnostic Monitoring is not implemented.
Sw1#show interface transceiver
No transceiver present
Sw1#show inventory
NAME: "TenGigabitEthernet1/1/3", DESCR: "SFP-10GBase-LR"
PID: SFP-10G-LR , VID: V01 , SN: xxxxx
NAME: "TenGigabitEthernet1/1/4", DESCR: "SFP-10GBase-LR"
PID: SFP-10G-LR , VID: V01 , SN: xxxxx
T06# show version
Cisco IOS Software, IOS-XE Software, Catalyst L3 Switch Software (CAT3K_CAA-UNIVERSALK9-M), Version 03.06.05E RELEASE SOFTWARE (fc2)
Switch Ports Model SW Version SW Image Mode
------ ----- ----- ---------- ---------- ----
* 1 32 WS-C3850-24P 03.06.05E cat3k_caa-universalk9 INSTALL
Sw2#show interface transceiver
If device is externally calibrated, only calibrated values are printed.
++ : high alarm, + : high warning, - : low warning, -- : low alarm.
NA or N/A: not applicable, Tx: transmit, Rx: receive.
mA: milliamperes, dBm: decibels (milliwatts).
Optical Optical
Temperature Voltage Tx Power Rx Power
Port (Celsius) (Volts) (dBm) (dBm)
--------- ----------- ------- -------- --------
Te1/1/3 39.3 3.25 -4.0 -2.9
Te1/1/4 37.7 3.28 -2.5 -14.7 -
Sw2#show inventory
NAME: "TenGigabitEthernet1/1/3", DESCR: "SFP-10GBase-LR"
PID: SFP-10G-LR , VID: V01 , SN: xxxxx
NAME: "TenGigabitEthernet1/1/4", DESCR: "SFP-10GBase-LR"
PID: SFP-10G-LR , VID: V02 , SN: xxxxx
Sw2# show version
Cisco IOS Software, IOS-XE Software, Catalyst L3 Switch Software (CAT3K_CAA-UNIVERSALK9-M), Version 03.06.05E RELEASE SOFTWARE (fc2)
Switch Ports Model SW Version SW Image Mode
------ ----- ----- ---------- ---------- ----
* 1 56 WS-C3850-48P 03.06.05E cat3k_caa-universalk9 INSTALL