07-03-2014 08:06 AM
Hello,
I have been trying to configure the Link Fail Alarm on SFP ports for a Cisco CGS2520 (Cisco CGS-2520-16S-8PC).
SFP: GLC-FE-100FX-RGD (10-2360-02).
I can create a new Alarm Profile and attach it to the Ports that I want to monitor. The update Profile can then be saved to the startup-config and the configuration can be viewed as being correct.
If I then pull a fibre cable the Alarm is generated as expected.
However when I reboot the Switch the Alarm Profile is still within the configuration but it is no longer attached to the ports (i.e. the Alarm Profile configuration is shown on the startup-config however the running-config does not contain the alarm profile on the SFP port). Therefore when the Fibre Cable is removed no alarm is generated.
I have run through the procedure as defined in Chapter 7 of the Cisco CGS2520 Configuration Guide and as stated above copied the running-config to the startup-config.
Is anyone able to advise why the port attachment is lost when the switch is restarted – the Alarm Profile is retained.
Thank you,
Darsh
06-06-2015 02:16 AM
Hi, did you solve this issue I am having the same problem.
06-27-2015 04:58 PM
Hi,
It was a known bug with the CGS2520 and firmware. Sorry I don't remember the Bug ID. Maybe you can check with the local Cisco support team?
Thanks,
Darsh
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: