cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1069
Views
0
Helpful
2
Replies

No LINK on port of Nexus5548UP

pslavkovsky
Level 1
Level 1

Hi

I have SFP-LH-SM in eth1/1 in Nexus5548UP but I have problem to get LINK on eth1/1.

I have SFP-LH-SM in eth1/1 in another Nexus5548P and it is not  problem to get LINK with same configuration of eth1/1

Is there some special setting for Nexus5548UP?

Is there diferent settings on interface on Nexus5548UP and Nexus5548P ?

Peter

2 Replies 2

Marvin Rhoads
Hall of Fame
Hall of Fame

The -UP model could have ports designated as Fibre Channel which would make the SFP-LH-SM an invalid transceiver for a port defined thus.

Can you provide output of the commands "show interface Eth1/1" and "show interface Eth1/1 transceiver detail" from the problem device?

Oleksandr Nesterov
Cisco Employee
Cisco Employee

Hi

Can you please try to set speed on the port and then insert the SFP module.

HTH,

Alex

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco