Si estoy realizando un diseno de red en topologica de anillo, usando el CTP en version 9.2, el diseno esta conformado por 3 sitios, cual es la mejor opcion para agregar un servicio entre dos sitios quiero que este quede protegido a traves del tercer sitios, usar un p-ring demand o ROADMs?
If I'm doing a topological network design ring, using the CTP version 9.2, the design is comprised of 3 sites, which is the best option to add a service between two sites want this it is protected through the third site , using a p-ring or ROADMs demand?
It would be helpful if the forum had customer support from in-region.
PRTG system in place running other sensors on the same host, which are working. Ive added syslog receiver sensor and receiving PRTG data from switch that increases drops, errors and warning stats that disappear after a few minutes. Within mess...
Hi, here is an example how to configure IP-NAT, GRE, IPSEC. I've seen plenty of questions and this might be a good solution! (Mostly the use of commands that might remind u) IP NAT======================================================================...
Hi everyone.I have a problem in my Network.So i have 3 routers and a firewall in my topology. I have configured OSPF and all routers works expect R3 (see in the image below)When I watch my neignbor in R3 it says :192.168.7.7 1 INIT/DROTHER 00:00:37 10.0.2...
Host Onboarding is the term used when connecting an endpoint (hosts , IOT , Other devices) to the fabric , and can be accomplished in a couple of ways.One option is the "static" approach as oppose to the dynamic and secure approach using&nbs...