I upgraded my Sonet 1545 this morning. The upgrade looked good. I was able to download, install and activate the software. I rebooted the ONS and now It will not boot. The lights just blink. I am not that well versed in this to determine how to get the system back. I see that there are flash cards on the main boards but I am not sure how to proceed
I had a similar situation on the Cisco ONS 15454 MSTP.
I hope you did save the database from NE.
You can try connect to ONS Control Cards vi console RS-232 port and see any message about error.
The RS-232 port is used to connect to the Transaction Language 1 (TL1) management interface. In TL1
mode, the RS-232 port runs at 9.6 Kbps without any flow control. Unlikely to help.
Or install this control card (TCC2,TCC2P, TCC3..) from your node into another node how standby card. Active card do procedure format standby card.You get working standby control card. Then do similar procedure for 2-nd card and
Hello!I'm looking for a way to make my EEM script more dynamic and automated for my environment. This is what I have - basically I just capture the 4 IPSec peer IP addresses of each neighbor and insert this data into 4 different variables. ...
Hi all,I have a couple of Nexus9k switches. I need to get tcpdump from the physical interface which connected to the server. I'm looking for a specific protocol on tcpdump so that which feature should I use? I asked that because I couldn't full...
We are building out our first few AAR polices and are running into an error message.Built Global Policy with SLA class and traffic rules for voice traffic, attached to to the sites and VPN we needed, no issue. Building a second policy for management ...
Cisco Champion Radio · S7|E45 Network Insights with AI Endpoint Analytics
Identifying who and what is on the network is a challenge for many organizations. Incomplete visibility makes it difficult to implement advanced security policies and recommendatio...