cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1089
Views
0
Helpful
2
Replies

15454 DWDM

steve554365
Level 1
Level 1

Any issues connecting two terminal nodes with these cards to transport a couple of channels:

Node A: 40MUX, 40DMX

Node B: WSS32, 32DMX

Thanks

2 Replies 2

chris-hart
Level 1
Level 1

I tried to model this in CTP but it doesn't appear to allow different mux and demux cards at each end, not sure what would happen if you used a 32 mux/demux model and just inserted the 40 mux/demux cards.

Marvin Rhoads
Hall of Fame
Hall of Fame

I'd think it would be a questionable configuration if you could even get it to work.

The 32 channel and 40 channel cards each use the same 8 bands with each using the same first four channels in each band and the 40 channel card uses a fifth channel in each. So when provisioning there would be nothing to prevent setting up a channel on the 40 channel card to go to the next node on an unsupported channel.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: