cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
732
Views
0
Helpful
1
Replies
jeff.alston
Beginner

2F BLSR cannot clear lockout

Greetings.

I have a 2F-BLSR and I upgraded from TCCs to TCC2s. All went well until I went to remove my locks from the spans, but it just locks up the whole network in that I have to reset (physically or manually) the TCC cards to get back to CTC!


I can clear one segment with no issues, but the second one hangs the system as above.

Fiber is running clean, zero errors.

Is there something I should look for or an order to bringing the ring back up to fully protected? It is running unprotected now.

????

Software is 09.208-101.H2606

1 REPLY 1
Tom Randstrom
Rising star

Have you submitted this case to Cisco TAC? 

Which control cards were you starting from, TCC or TCC+?  I don't believe it would be possible to directly upgrade from a TCC to TCC2 without using a TCC+ card in-between (due to software compatibilites). The TCC is compatible up to 2.x, The TCC+ up to R4.1, the TCC2 starts at R4.0.