Optics and Optical Networking

I have 2 EWDM muxes in a lab and would like to set up a test connection over X2-10 GBics. I have 10 db attenuators which I could connect on RX end or on both both the TX & RX ends avoid any damage.Question: Due to the distance being short, could this...

I have many Cisco ONS 15454's deployed, and I need a way (I presume from CTM) torun reports to show1 - Circuit utilization (how many STS-1's and for which clients are provisioned on all spans)2 - Capacity report (how much capactiy in STS-1's are avai...

Hi everyone,I need a media converter that takes in fibre connection and gives Ethernet output(gigabit).Can you provide me the part number please?thankssam

   I have a Cisco MDS9124(namely 9124a) connected to a brocade4Gb(which is located at the back of a IBM BladeCenter enclosure), both working properly. Now I want to add another MDS9124(namely 9124b) into this existing fabric, and connect this 9124b t...

Hi,i want to connect 4506-e and 6506-e with 10gb technology .Which modules and gbic are required?Thanks

Quick question, I setup an iSCSI evironment using a 3750E with 2 Tengig ports.  I connected the SAN to Te1/1/1 yesterday and all worked fine.  Today Te1/1/1 was down and wouldn't come up.  So I moved the SFP to Te1/1/2 and it came up without fail.Te1...

HiI am looking to Design a network with 3750 as core Switch and 2960 as Edge switchCore Switch - 3750 24-FSEdge Switch  2960 24 Base T with 2 SFPSo my question is Can i connect the uplink between core and Edge switch using Single Mode MT-RJ at core e...

We have some ONS15454 deployments running OS version 9.1 & 9.2.1.  Is it possible to SNMP poll for individual module (fru) service status?2.  If yes, can someone advice which MIB to use (oid would be good too)?Thank you,Cameron.

Hi,I am facing competability problem  between CISCO 12010 router's POS port with SDH STM1 PORT(MUX).So we need to  change s1s0 values on router POS port..I cant see pos flag command at cisco 12010 router's  pos interface.I can  have it at remote end ...

Hello, we have a older 15454 network with OC3 ring between the nodes.  My issue is we are trying to provision an ethernet circuit between two nodes on STS3 and its not working.We are able to provision the circuit on each end and it shows green but no...

we want to set up a test-bed in which three optical add-drop multiplexer (OADM) will be connected through optical fibers. The OADM will be connected to IP router in the electronic domain, and we will be able to send data from one computer in one lo...