Hi everyone. Please consider first scenario ( packet switched network) CE f0-----------fe PE--rest of network CE is using CIR 10M CKT, PE has inbound policer for 10 M, bc 2M ( bits). CE is shaping its traffic to CIR 10M, with matching bc 2M to e...
Hi Guys , I need some assistance regarding CTC, we got one project in which the traffic is already flowing with two networks reflecting redundancy of DWDM. Now the issue is that on CTC, we can only see one network with all proper configurations. But ...
Hello , I am new to the 40Gbps world. I was quoted the above cable for cabling my nexus 9k. Is this what we call a DAC cable? Does the cable really have 2 40Gbps SFPs at both end? Thus i wont require additional SFP right? Will it be compatible ...
I currently have multiple SG200-26P switches and am in need of the correct equipment list to interconnect these with fiber. Any help would be appreciated.
I have configured a 100G-LC-C card paired with a 10X10G-LC card in MXP mode. The one node is in-service but the other side has an OTUK-LOF alarm/LOM condition as well. I've changed fibre patch cords from the odd shelf to the card but my levels seem...
Hi Friends, anybody knows how to show fiber status in router 891? if we use this command it shows us only S/N and other values but not Fiber RX and TX sh controllers gigabitethernet 8 | beg PHY PHY Registers ------------- Register 0x00: 1000 ...
Cisco CTM 8.5 supported NE table. Can NE version 03.41-002K-08.22, 04.00-003C-08.05, 04.10-003F-20.23 be upgraded to a higher version without a hardware upgrade to the node. In CTM I am receiving a Inservice Unreachable. Is there anything that I can ...
Was wondering if anybody out there would be able to help me out with an error that we are getting on our Cisco 15454 platform. We are trying to manually build a circuit with protection but everytime we do it errors out with the error "EID-2330 An err...
Switch--2--switch connection. (same switch at both end) Both ends configured with the below configuration. # int gi1/0/25 #switchport mode trunk #switchport nonegotiate but still, the fibre link not detected, even tried with the different confi...
I have a device to which I need to connect a catalyst switch (2960XR). The device has a 100base fx interface which they state as capable of running over single mode fibre. The vendor of this device has suggested connecting it to a SFP that supports 1...
Hello, Could someone clarify about the use of FO splitter in Cisco switching environment, I have a requirement that i will be running 2 core FO cable from Core switch location to access building (60 buildings). Each access building has 6 edge switch...
I'm looking for clarification for the NCS DC PMs. I understand the matrix for redundancy configuration i.e 1+1, 2+0, etc. and it clearly states that any combination of PMs can be used. But I'm confused about the matrix for power module settings as s...
HQ (Cisco WAN) <-> Region (Riverbed WAN) I have a question about compatibiltiy WAN Equipment. Is it Possible?
Our company bought several 40G to 10G adapters (part no.CVR-QSFP-SFP10G). I have experience with this type of adapter so I expected this device to be a passive feedthru device that allows me to configure and status the SFP+ module that I plugged int...
Hello Guys I have two 3850 with the same IOS version and the same transceivers model but only one shows me DOM and the other does not Does anyone know what's going on here? Sw1#sh int tenGigabitEthernet 1/1/4 transceiver detail Diagnostic Monitor...
