Optics and Optical Networking

Hi Guys,I  am faced with the challenge of connecting 2 core switches located at  different building about 2 Km distance from to each other. I choose to have on one end, the  core switch WS-C3750-24TS-E  and the other end with same core switch WS-C375...

We've been trying to recover the admin password on our two MDS 9124 fiber channel switches using this documentation from Cisco: http://goo.gl/xeyZvHas anyone done this successfully?  When I hit step 10 to "load bootflash:IMAGE.bin" after changing the...

CPT600 running with CTCR95.  There are 3 FOGs,Group ID 39 - FOG39 - Ten GE Port 1 of Slot2 PTM-4 card and Ten GE Port 2 of Slot2 PTM-4 cardGroup ID 37 - FOG37 - Ten GE Port 1 of Slot4 PTF-4 card and Ten GE Port 2 of Slot4 PTF-4 cardGroup ID 38 - FOG3...

Does the 10Gigabit Ehternet over multimode fiber (mode conversion cables, etc.) protocol support fiber runs in excess of 2km?Does Cisco have a postion on its hardware and MMF lengths?Has anyone tested this orknow of a paper on the subject?

Greetings.I have a 2F-BLSR and I upgraded from TCCs to TCC2s. All went well until I went to remove my locks from the spans, but it just locks up the whole network in that I have to reset (physically or manually) the TCC cards to get back to CTC!I can...

Hi ExpertsI  want to connect two san fabric switch away from each other 20KM using a  dedicated fiber in order to replicate san traffic , question is what  transceiver on san fabric should i use to terminate the fiber cable  coming from the MUX ,is S...

Hello,I would like to know if it's possible to use SFP-10G-LR with a conditioning patch cord ?In fact wa have to deploy 10 Gb, but we dont have any information on the FO, so we have to figure the worst case: old SMF.It seems not, but I would like to ...

Is there any documentation which product comes with empty SFP/GBIC slots and which full? Actually I interested with ME-3400-24FS-A model.I need SFP module 10/100 with SC connector type (20 km) which works on a single mode. Can anyone advise me which ...

Hi All,Can someone please clarify the difference between 10Gbps LAN Phy and WAN Phy?Is there is a preference between using either/or?

Greetings All!How much attenuation loss should be allowed (upper & lower range) for 10Gb link between Cisco XENPAK-10GB-LR & HP BLc 10Gb?Thanks. Regards,

Hello team!Is it possible that the SFP-10G-LR will work with multimode fiber?I totaly understand that this actualy depends on cable type and lenght, but I do not have this information right now.So, if someone have succes or bad story I am happy to li...

Dear All,does  SFP-H10GB-ACU10M come with SFP+ connectors?or it is just a cable and we need to provide the SFP+ Transceivers??thanks

We are looking at getting the SFP Mini-GBIC from HP HP-J4858C.  This transceiver module is Gigabit-SX-LC Mini-GBIC.  Will this module work on our Catalyst 2960 PoE switches and will it also work using a MultiMode fiber?

HelloI need to connect a surveillance camera that is 2000 ft away from my router, should I use an optical network?, or how can i do it? I´m new to optical networking!