cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1044
Views
0
Helpful
2
Replies

ONS 15454 M6

Alex Trajano
Beginner
Beginner

Hello!

This one is regarding an M6 shelf.

In the network connectivity diagram attached, the SMR2-C-A does not have a connection with a TNC Card to its OSC-TX and OSC-RX, will it work? How can I enable the LINE-TX port of the SMR2-C-A so that it will have a connection with the other node?

Regards,

Alex Trajano

2 Replies 2

scnoyes
Cisco Employee
Cisco Employee

Alex,

You should be able to do this but only with a DCN OCHNC circuit

You have to have LAN connected nodes & build a network level PPC. 

Once the PPC is built you should be able to  build a DNC OCHNC (on each side)

then you can combine them.  DCN OCHNC is basically telling the system there's

no OSC but you have LAN connectivity to each node and to ignore Optical safety

This can get pretty complicated and is hard to explain via email.  I suggest you open

a TAC case and work with someone directly.

-SteveN

oishtiah
Cisco Employee
Cisco Employee

Hi 

Can I know from where you get the tool to draw this connectivity diagram, please 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: