cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1007
Views
5
Helpful
3
Replies

ONS15454 Subtended Shelf VLAN

chris-hart
Level 1
Level 1

Hi Does anyone know if you can configure the subtended shelf in a muli-shelf configuration into a VLAN other than the default VLAN 2.

Chris

2 Accepted Solutions

Accepted Solutions

Tom Randstrom
VIP Alumni
VIP Alumni

I don't know the answer but the following Cisco discussion might provide some insight.

https://supportforums.cisco.com/thread/2055162?tstart=30

View solution in original post

mayfwh
Cisco Employee
Cisco Employee

Chris,

Starting in 9.1, you are able to select the private VLAN.

Here is the relevant 9.1 documentation:

Procedure Guide Chapter 1:

http://www.cisco.com/en/US/docs/optical/15000r9_1/dwdm/procedure/guide/454d91_installshelf.html

NTP-G159 Configure a Cisco Catalyst 2950 for a Multishelf Node

or

NTP-G294 Configure the MS-ISC-100T Card for a Multishelf Node for Non-Default Public and Private VLAN IDs

Procedure Guide Chapter 2:

http://www.cisco.com/en/US/docs/optical/15000r9_1/dwdm/procedure/guide/454d91_turnupnode.html

NTP-G144 Provision a Multishelf Node

Thanks,

Will

View solution in original post

3 Replies 3

Tom Randstrom
VIP Alumni
VIP Alumni

I don't know the answer but the following Cisco discussion might provide some insight.

https://supportforums.cisco.com/thread/2055162?tstart=30

mayfwh
Cisco Employee
Cisco Employee

Chris,

Starting in 9.1, you are able to select the private VLAN.

Here is the relevant 9.1 documentation:

Procedure Guide Chapter 1:

http://www.cisco.com/en/US/docs/optical/15000r9_1/dwdm/procedure/guide/454d91_installshelf.html

NTP-G159 Configure a Cisco Catalyst 2950 for a Multishelf Node

or

NTP-G294 Configure the MS-ISC-100T Card for a Multishelf Node for Non-Default Public and Private VLAN IDs

Procedure Guide Chapter 2:

http://www.cisco.com/en/US/docs/optical/15000r9_1/dwdm/procedure/guide/454d91_turnupnode.html

NTP-G144 Provision a Multishelf Node

Thanks,

Will

Thanks guys, I knew I thought I'd seen it somewhere, just couldn't remember where.  As an aside I actually requested this functionality over 2 years ago so I may in some small way have been instrumental in the enhancement.

Thanks again

Chris