08-01-2016 02:31 AM
Good day,
I have Cisco 2911 (EHWIC-1GE-SFP-CU , GLC-SX-MMD, LC to SC Adapter. I want to configure PPPOE on cisco SFP port as diagram bellow:
Cisco R2911 (SFP Port) ---- (SC - LC Adapter) --- ISP
interface Dialer1
ip address negotiated
ip mtu 1452
ip nat outside
ip virtual-reassembly in
encapsulation ppp
ip tcp adjust-mss 1452
dialer pool 1
ppp authentication chap pap callin
ppp chap hostname XXXX
ppp chap password 0 XXXX
ppp pap sent-username XXXX password 0 XXXX
ppp ipcp dns request
interface GigabitEthernet0/0/0
no ip address
media-type sfp
pppoe enable
pppoe-client dial-pool-number 1
I had checked Dialer1 (up up ), GigabitEthernet 0/0/0 (down down), Fiber Cable (working) >>> It doesn't work
Anyone can help me how to fix this problem.
Thank you so much
Sang
Solved! Go to Solution.
08-01-2016 04:25 AM
Hi,
http://www.cisco.com/c/en/us/products/collateral/interfaces-modules/gigabit-ethernet-gbic-sfp-modules/product_data_sheet0900aecd8033f885.html
Table 1. SFP Port Cabling Specifications
08-01-2016 04:25 AM
Hi,
http://www.cisco.com/c/en/us/products/collateral/interfaces-modules/gigabit-ethernet-gbic-sfp-modules/product_data_sheet0900aecd8033f885.html
Table 1. SFP Port Cabling Specifications
08-01-2016 08:43 AM
Hello kayukovvalera,
Thank you for helping. I had called for ISP to check what are their fiber mode using yesterday? They answered "It's Single Mode" then I had bought SMF Cable and it's not worked. If I change SMF to MMF cable as your suggest and is it worked with ISP Single mode ?
Thank you so much.
Sang
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: