02-01-2006 08:27 AM
Hi,
Please let me know what all standard/proprietary OAM (Operation,Administration & Management) tools are available for managing/troubleshooting faults in WDM and SDH networks.
Regards
Gaurav
02-01-2006 11:08 AM
If it's a Cisco-based network (ONS 15454 and such), one can use either the built-in Cisco Transport Controller (CTC) or the big brother Cisco Transport Manager (CTM).
02-03-2006 01:25 AM
Hi,
I am looking for OAM standards available for WDM/SDH network troubleshooting.It would be great if anyone can share with me some good URL on this.
Regards
Gaurav
02-01-2006 01:24 PM
If you want to use a 3rd party, you can install netoptics network taps
www.netoptics.com You can then have this feed to a system such as HP openview.
02-06-2006 06:48 AM
A passive tap will require a device to analyze/interpret the data stream. HP OpenView is an IP network manager, replying on snmp for information. SONET/WDM typically uses inline OAM signalling for error detection and provisioning. Vendor-specific solutions tyipcally are used for tapping into that data stream.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide