Other Cloud Subjects

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Save 25% on Day-2 Operations Add-On License

 

Forum Posts

I'm beginner at networking, I notice that after configuring a network when I try to test the network connectivity with sending msg every time at the first attempt It always says "Failed" and then it says "successful" . what is the reason ? NJMCDirect

I have deployed an asav on an ec2 instance in aws. When I connect to it there is only 1 interface (management) . Every guide I have read requires me to configure the gig0/0 interface. It doesn't exist. I can't connect via asdm .

Nicolette by Level 1
  • 501 Views
  • 0 replies
  • 0 Helpful votes

 This documentation assumes your Cisco Firepower 2130 ASA is running 9.13.x code to support Appliance mode. I'm not going to go into details on how to do this..- We are also assuming that under your "AnyConnect Connection Profiles" section you enable...

LillaKoch by Level 1
  • 562 Views
  • 0 replies
  • 0 Helpful votes