Auto QOS on turnk link to router

[level3tech]

Hello all,

Using the auto qos trust cisco-phone command with establish my trust boundry on the phones. So any packets will be marked by the phones. When this traffic is passed to the router, would i set up the ethernet interface on the router wth auto qos voip trust? What would i do on the switch? Would i do the same thing on the switch and then config the router to mark traffic sourced by it leaving the ethernet interface going to the switch?

Thanks!

[aamercado]

phone----switch--router

1. setup auto-qos on switch which u did

2. assuming you have srst sites, setup outbound qos depending on your wan link

3. on switch ports connect to routers, do not setup autoqos, and depending on your switch, you set up the qos. For instance on L3 switch port to the router:

mls qos

mls qos trust dscp

check out the qos srnd at

www.cisco.com/go/srnd