Hi I have cisco 7970G connect to non cucm, the phone is on but dont receive any number, Would you help me?
Hi I have cisco 7970G connect to non cucm, the phone is on but dont receive any number, Would you help me?
We have noticed laptops reduced battery life when Proximity agent is loaded on to a laptop. It runs the battery down almost 50% faster. A 5hour battery life is reduced to 3hrs with app then back to normal when app is removed. What can be done here ...
Hi AllI would like to have cisco webex stencil icon like following documentsHow can I obtain these stencil Can someone help me for that ? https://help.webex.com/en-us/article/b6vrdc/Cisco-Webex-Edge-Audio-for-CUBE-Customer-Configuration-Guide#Cisco_C...
Hello All, I'am working on one of these new UCS's BE servers that was shipped with ESXi 7.0 and I cant figure out the default password. I need to back it ESXi 6.7 but i need to get in first to get the licenses so I can downgrade them. Thanks Jas...
What are Tandem Calls? They show up in ART and im not sure what they represent...
I have a large campus environment with an old ROLM PBX. The ROLM PBX had PSTN connectivity via multiple T-1 CAS circuits, and received it's clocking from two of the T-1s. We've since migrated PSTN connectivity over to two SIP trunks connected to two ...
Hi, Trying to get below working but not sure which SIP message that CUBE receives is the one that I can use to change the CLI in outgoing Invite - hopefully its the Refer itself. CUBE receives multiple messages as part of the Refer. 1. CUBE receives ...
Hello, We want to setup CUBE having multiple SIP trunks, but we want to totally separate the dial-peers for every SIP trunk so that when the call will come on CUBE from provider 1 it will only match the dial peers of that specific SIP trunk.Incoming ...
If devices already have existing device certificates used for other purposes from the same trusted CA, is they any way to configure ASA to require a more specific device certificate that will be dedicated for management VPN tunnel authentication?For ...
Hello Team, We have a ISR 3925 VoIP Gateway with a Primary ISDN line. When in a call, the far end is placing on hold the call, the call is dropped, you can see the below traces: *Jun 29 08:47:15.168: ISDN Se0/0/0:15 Q931: RX <- NOTIFY pd = 8 callref ...
Hello everyone! Our new ITSP send in INVITE as display info the calling number and we need to remove it if possible on the outgoing dial-peer. In this example, here the incoming SIP message: Here the outgoing how we would need it: I think it shou...
Question for anyone who used NSO with CARE to automate STIGs.So we had call yesterday with a few guys from Cisco to discuss us potentially ordering Cisco NSO. The main reason for purchasing is to use their CARE product which will allow us to automate...
One of my customer have CUCM solution On-Prem 12.5 and they have already Cisco WebEx subsciption. Webex have license 250 Users CUCM have 450 Users How do i integrate and what license do i required for this.
I wanted to put this question out here hoping I might get some feedback on others’ experiences with PCD.Personally I have not been a big fan. I typically do upgrades and migrations by hand.But I have a project coming up where PCD would be a good fit....
Hi all,I am trying to forard the voicemails to the end user's email. I have followed the steps, I have set up the smart host with the SMTP relay server IP, which relays the messages with the from field being voicemail@mydomain.com.When a user (let's ...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Subject | Author | Posted |
---|---|---|
04-22-2024 04:46 AM | ||
04-18-2024 07:46 AM | ||
04-15-2024 07:41 PM | ||
04-09-2024 02:09 PM | ||
02-25-2024 06:28 AM |