Dear All,My CCM version is 4.0(1)sr2a. I would like to upgrade it.Do I need to buy license to upgrade it to version 4.0(2)aSR2 or 4.1(3) respectively?Thanks.C.K.
Hi,We have CCME 3.2 installed on Cisco 3825 router.When somebody call from outside through PSTN to the operator,he is able to transfer to an extension but not to any PSTN number.He gets a fastbusy tone when he presses transfer & dial the seize code....
I have a CME 3.2 2611XM w/ AIM-CUE software version 2.1.1. IOS version 12.3(11)T6. I for some reason get a lot of static one way on the 8 analog lines coming from the PSTN. Callers from the PSTN hear people on the CME fine but not the other way ar...
We are located in Laredo, Texas and are openning an office in Monterrey, Mexico. Can i use an ATA-186 or ATA-188 for this remote site in Monterrey to connect to our call manager in laredo? We are familiar with softphone but thinking of getting local ...
I have CCME 3.2 setup on 1760 route with VIC-2FXO card.IP Phones #1 to #10 are installed ( 10 phones).I need to do:1. to ring phones #1 and #2 in incoming calls on line #1 on FXO card andto ring phones #3 and #4 for the incoming calls pn line#2 on FX...
Does anyone have an idea of what these disconnect codes indicate? From what I can find, it appears to be a problem at the remote end, but just wanted to confirm. We have calls drop at random times and we are trying to get to the bottom of it.May 16...
Does,Somone have an idea what the problem can be when I try to Encrypt the User ID and Password by using the LoginSecure.asp, when I get this error message:Decoding Exception: 16389java.lang.ArrayIndexOutOfBoundsExceptionThx..
Does anyone have a simple app they can share to post updates to the AXL interface? I am not a programmer and am having a tough time trying to get something to work. I have to add about 100 route patterns to 20 different partitions and would like to...
Is it possible to configure Extension Mobility for IP Communicator Phones or can it only be enabled on Hardphones? Using CCM version 3.3(4) and IP Communicator Version 1.2. Thanks
Hello,I have a CCM 4.0(2),my problem is that the memory utilization increases everyday.I have to reboot the server at lease once every two weeks.After rebbot the memory utilization will become low again.I have already applied the latest patch.Have an...
Hi,Is it possible to select a dial peer based on the calling number and NOT the called number?eg. Phone extensions 7XXX uses dial-peer 1, and phone extensions 8XXX uses dial-peer 2. Both dial peers have the same destination pattern.Is this possible?...
Hi,Is it possible to forward or redirect a call from a H323 gateway to another H323 gateway ??. I may sound stupid,But what I really wanted was to place a call from a PBX and send it to H323 gateway through T1 trunk . It matches one of the dial-peer ...
Hi,Recently far end users have started to exeprience call drops over the WAN from many of other connecetd sites. Typically at each location we are using c3662 routers with either E&M or FXS/FXO ports plugged into the the PABX.The setup has been worki...
Hi, I want to use AXL API programming to and request getPhone method to get information about a phone. I followed the C/C++ example in the guide and imported the HTTPHeaderrequest and SoapXmlrequests from it.However when I post it, I get "An unknown...
