Other Collaboration Subjects

I have CCM 4.1 installation with 2650XM route as vocie gateway.It has NM-2E1 card for voice connection.Link #1 connected with voice service provider (ISDN PRI) and takes line clock from service provider.Link #2 connected with the local PBX and provi...

i have a store with 10 phones with multiple lines..i want to be able to use intercom to broadcast through the speakers of all the phones in the store.is this possible and how do i do that?

I have configured a cluster of two CM i.e. 1 Publisher and 1 Subscriber. All phones are configured to use the Subscriber as the primary CM and the Publisher as the backup.Now I have configured Option 150 pointing to both the CM ip addresses on the L3...

Folks, I have a remote site connected via 2 T1's. I would like to do load balancing. What would be recommended if it is a voip environment? per packet or per destination?Thanks

Hello,I'm using a Cisco 3825 with CME 3.3 supported on IOSc3825-spservicesk9-mz.124-1a.bin.According to Cisco CallManager Express 3.3 Specificationshttp://www.cisco.com/univercd/cc/td/doc/product/voice/its/cme33/cme33spc.htmI should be using the foll...

Hello,we have a CCM4.1 with 100 Phones and a POTS with 400 Phones connected over E1-PRI on Cisco-3660-Router. The telephone numbers are on both systems without uniformity distributed.Thus I have on the router for each number extra an entry in this fo...

HiI have a CallManager version 3.3.4 and works OK.The only issue is CallManager user's pages. When i access to my user page doesn't show me Options.Attach a jpeg picture.Please help.Thanks

Hi,I have a problem with hear the ringback in a h323 gateway after to use a tcl call aplication.I have some DID in this gateway and when i call these, i hear the ringback, but when i use the its-CISCO.2.0.1.0.tcl i don´t hear the ringback.

I will be replacing a MRP300 tonight is there anything special other than pulling the card out and pasting in my backup config? I am unable to find a doc on cco for MRP replacements only SPEThanks,

Can anyone help me out with this one.I have a need to not display the ID of the user whose profile is logged into a phone, when the user is being logged out.So instead of showing "Logout Paul?" it just shows "Logout"Anyone know how I can achieve this...

In CM 3.3 when you enabled auto answer on a phone, the answering partywould hear a short beep/zip tone befor the call would connect. It lookslike that is no longer the case in 4.1 and I can't find a serviceparameter to enable it.

I need to setup an application based on clients doing call forwarding to my ciso 1760v router. Problem is, when my clients get calls, instead of seeing their own phone number on my router, i see only the number of the party calling my client. How can...

I am unable to login to IP phone.Error displayed is "Directory Services Error"Where as I am able to login to the IP phone using a different login id and pin.Please help

Hi,i made a custom page, which displays on a phone after the idle timeout.There is a button on it to login/out via extensionmobility. This button goes to a web page via http://x.x.x.x/emapp/EMAppServlet?device='name' where name is de devicename. I ge...