Other Collaboration Subjects

New install of CER 1.2(1) in a CM 4.0(2) cluster, CTI Ports not registering in CM. CM Event Viewer shows CTIManager error: "The JTAPI/TAPI application version is not compatible with this version of CTIManager, so received message has neen rejected. V...

Hi, i have two 2620 in h323 gatekeeper mode coneceted to PBX with E1, sometimes it make a congestion tone.how i can do make a debug or troubleshoot to find the congestion?thanks..

Has anyone had experience integrating CCC with an Avaya G3? What components are necessary besides the CCC HW/SW, CallManager HW/SW, and router?

Is any way to disable the handset microphone when someone chooses to use the headset. Or to disable the hand set entirely?Can this be set up as a default for a Cisco 7960 phone?

Will someone help me with this?(enable) set port ena 3/8Failed to enable port 3/8.Port host processor not online.(enable) sh modMod Slot Ports Module-Type Model Sub 3 3 8 T1 WS-X6608-T1 no okThanks

Hallo,do somebody know how I can configure "Distinctive ring tone" for internal/external calls?Thanks a lot in advanceBest Regards Martin

I would like to modify 2 parameters and I am not sure how to do it.1) Forward Busy -- This is currently blank, but I would like it to be the same as the extension, but in a different partition2) Alerting Number -- I would like it to be the same as th...

I have a router configured as h323 gateway talking to a call manager, i also want this router talking to a sip proxy (not cisco), so SIP endpoints can call Cisco IP phones on the call manager. Can this conversion be done on the router? i know call ma...

Hi all,In the documentation about the Line/device approach for routing and restrictions, Cisco says that caveats are for Call Forward that the CSS used is really "none" if "none" is configured in the CallFwdAll box.Therefore, I would think that if i ...

I am using several 7960 phones that are using multiple extensions. The problem is that only the first extension is showing voicemail via the red indicator light. Is there a phone load for the 7960 that allows the red light to be on when there is a vo...

Guys,Reading the Cat QoS book, and on page 258 (or approx) it seems to indicate that if you have a line card that supports ports that have a priority receive queue, you can only put frames into this queue if it comes in on a trunk (isl or dot1q), if ...

Hi All,Can anyone please give me hint on how to change the disconnect tone on the FXS port, when the remote party hangs up? The "cptone" command doesn't effect this tone.Thanks,Attila

hello,

I have a ccme running on a 2801 router with a vic2-2bri-nt/te on it, but although I have configured it and I can make calls from my ipphone to PSTN I cannot receive calls originating from the PSTN. Does anyone know if I have to make a dial-peer for t...

Is it possible to create a SINGLE Route Pattern that will cover 800,844,855,866, 877, and 888 without using a route filter?9.18[0,4-8][0,4-8]XXXXXXX will still match more than the above area codes. Anway, just curious.