Other Collaboration Subjects

Has anyone tried to connect 2 sites together over the internet using Cisco routers behind Linksys?Typically Remote site looks like this:Cisco Router-->Linksys-->INTERNET-->Cisco 36xx(MAIN)The Remote Site is doing a GRE Tunnel to the Main Site on the ...

It has been a few months since I install CCM. The last one I did was a 3.34 deployment. I have a 3725 router as the voice gateway I would like to run a paging system off of it connected to a FXO port and run MGCP for the gateway part. Can I run both ...

On a sniffer pc happened to find CCM is generating the multicast to 239.1.1.1 . After check found that ccm is configured as multicast for the MOH. We disabled the multicast in several places: audio source, moh server and MRG and reset the MOH server ...

HiWe have CCM 3.3 & two gateway router(for redundancy) connected to PSTN.GW1 is connected to PSTN through E1 link has a DID range(say 52567XX given by SP.GW2 is connected to PSTN through 7 FXO ports & has a different range(say 72565XX) of number give...

Hello,My setup is CM 4.0(1)sr2 with voice gw 3745 IOS 12.2(15)ZJ3. Using H323 between CM and voice gw. When PSTN caller calls to IP Phone, the IP Phone user can't hear caller's voice for the first 3 seconds, afterward the conversation goes two-way. H...

We have a new 3.3(4) Call manager cluster with the subscriber listed as highest priority in the Call manager group. The phones are registering to the primary call manager instead of the subscriber. If we shut down the primary the phones won't regi...

Hello,We have just installed CCM 3.34. We installed the art plugin succesfully with no errors. But when we try to login to art we get page not found. All services look like they are started.

I have a CMM gateway with callmanager 3.3.4. The T1 module is in slot 3 in the CMM card. Is working with the fastethernet 4. I have this message duplex mismatch discovered on GigabitEthernet1/0 (not half duplex), with Fastethernet 8/4 (half duplex). ...

All,In the UK we dial "0" to speak to the Operator. Where IPT stretches across multiple sites we want each site to route to a different operator when "0" is dialled.Setting up one pilot point with DN "0" and a local partition only accessible to phon...

Just upgraded from 3.2.2 to 4.01(sr2). After the upgrade none of the previous call pickup groups are working. Do I have to configure hunt groups or is there a setting that I've missed.Thanks Jim

Hi,I'm using a Cisco 5350 to terminate h323 calls to PSTN. The call is authenticated with a remote_ip_authenticate script in porta radius server and is sent out. When is disconnected, the accounting info is sent to billing. The problem is that some c...

Hi,Can a PA user be a manager in IPMA?I am using CCM333 sr4a.This is because I receive an error msg at the IPMA conf. screen stating that " no devices are associated with this manager".This error msg will not appear if I delete the PA cti route point...