Other Collaboration Subjects

I looking at a 2600XM with CCME 3.1 and AIM-CUE and using either the NM-HD-2V or 2VE module with VIC-4FXS/DID and was wondering if the FXS ports have to have PVDM like a AIM-VOICE-30 card so that the FXS cards terminate to?I do not believe that you n...

I am integrating Active directory 2003 with Call Manager 3.3. AD container contains all the user information including the 10 digit phone number for the users.When IP phone users browse thru the coporate directory and press dial, I believe call manag...

2651XM with CME and TCL based AA running, the AA will answer the outside FXO, but what i'm really looking for is the ability to ring a DN on a phone (reception) and then goto AA after 4 rings. Possible? If I dial the e-phone DN for the AA it just r...

Hello,I have an interesting scenerio.I have all 7960's connected to CCME 3.0 on a 3745.All phones are up and running fine.I configured button 1 to be dual-line for there main number.I configured an Intercom DN for each user as well and assigned it to...

I have an IP Phone 7970, connected onto a non-Cisco LAN Switch. After using for a very short period of time, the switch port disable itself. Even I disconnect the IP Phone and plug a normal PC onto that LAN port, it can't be workable again. I've t...

Hello to all gurus!I have the following prob.I have designed IP Telephony for a branch with 95 IP Phones based on the 3745 platform with CCME which is clearly stated to support 120 IP phones according to this: http://www.cisco.com/en/US/products/sw/v...

yada, yada, yada....I have all the progress_ind, voice call send-alert, voice rtp send-recv, tone ringback alert-no-PI, and I am still getting no ringback on inbound calls from the PSTN. I am stumped....memory-size iomem 10clock timezone CST -5clock...

I have a customer that has run out of lines on their 7960 phones. They have a single appearance key of their main number on 10 phones. Of course when that line is active they can get any more calls. Is there away to setup hunting for that many phones...

I'm looking for CM limitations such as maximum number of sets on which a shared line may appear and maximum number of shared lines that may appear on one set, for 3.3 and 4.0.TIA

There are 5 types E&M. When we talking about E&M 2/4 signaling wire, is that only for the analog trunk E&M or also refer to T1 CAS E&M? If it's also for T1 CAS, how can I know use 2 wire or 4 wire in South America?Thanks

Is there a way to get CDR logs to show all data for a given time period vs truncating after 99 events?

I'll connect a T1 of a Cisco router 3725 to a Motorola FRAD T1, which use another interface connects to remote Motorola FRAD through the FR. T1 CAS will be running between 3725 and FRAD. Do I need special configuration, like which one is network inte...

Does this effectively alleviate the requirement to have multiple pots dial peers - one to reference each voice port? Thanks!voice-port 1/0/0 trunk-group OUTBOUND!voice-port 1/0/1 trunk-group OUTBOUND!voice-port 1/1/0 trunk-group OUTBOUND!voice-port ...