Other Collaboration Subjects

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Forum Posts

Problem:IP Softphone won't go off-hook unless associated with a device.When the softphone is associated with a device, all is well.When the softphone is not asscociated with a device, I still see lines to attach to, however, the phone won't stay off-...

cfeleppa by Level 1
  • 405 Views
  • 2 replies
  • 0 Helpful votes

On CallManager, users are unable to pickup the call using the default template in the CallManager. Configuring the Speed1 button to be the call pick up button on the 7910 phone. Its initial deployment were working properly but now suddenly the pickup...

crisol by Level 1
  • 375 Views
  • 3 replies
  • 0 Helpful votes

Here is the scenario1. This is a new install ;) 2. They have 4 7960 phones that all roll (line 1 is 5555, line 2 is 5556, line 3 is 5557 and line 4 is 5558, lines 5 & 6 are open). 3. The pilot number for a police department is 5555....

bwd by Level 1
  • 426 Views
  • 4 replies
  • 0 Helpful votes

Is there a method to configure call manager to "Send All Calls" or use the divert option offered for IPMA without using IPMA? I know 4.0 incorporates iDivert, but the client is on 3.3.2c and is not ready to upgrade, even if the fit the limited rollo...

raortega by Level 1
  • 347 Views
  • 2 replies
  • 0 Helpful votes

I have a Dial-Peer on a ios gateway, when i change the bytes per packet i.e. "Codec g711ulaw bytes 240" I can make one call, and afterwords the port sticks in an off hook state (FXS Port) and I get DSP timeouts basically. I have tried this on a 2651X...

rcfoltz by Level 5
  • 369 Views
  • 1 replies
  • 0 Helpful votes

Does anyone have a sample TCL script for a simple auto attendant on a router? Where it will play one wav file and be able to give you options for [0-9,#,*] or even be able to transfer to an extension. Nothing fancy here.Thanks in advance

p.coiner by Level 1
  • 283 Views
  • 1 replies
  • 0 Helpful votes

Has anyone run into this. Attendant console operator parks a call, shows up in pane as parked at xxx. Client takes the parked call and the hangs up, but the console operator still sees the call as parked.

whanson by Level 2
  • 398 Views
  • 4 replies
  • 0 Helpful votes
Top Solution Authors