Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have configured a phone in Call Manager and the VoIP is registered it can receive calls and they are clear on both ends. The problem is when the customer tries to dial out. The full number is entered but the phone only dials the first 2 digits. Ha...
I've got a VG350 with SCCP registered FXS endpoints. The client has an interesting requirement. If an analog endpoint is offhook for 10 seconds and no digit is dialed, redirect the call to the operator. Can this be done at the gateway level? I lo...
I am working through configuring new 4451-X routers to support voice. I have 1 pvdm in the NIM Card. This gateway has slots on the motherboard for the PVDM and a slot on the NIM. I have relocated the PVDM to the NIM.
My question is, when I enabl...
Hello
I have a question on Cisco Proximity for wireless projection on Cisco MX series, SX series and the IX5000. Is the product fully functional on PC and MAC or it is still in beta mode?
Regards
I have 8 lines running off two VG204 Gateways. The caller ID used to display on the phones, but now the display reads "No Caller ID on AIM147". The customer stated it worked until a couple months ago when everything was "rebooted". Any ideas on what...
Hi
can i ask. i am going to install the vcs and vcse on cisco ucs c220 M3 Bundle. so are the vcs and vcse already installed by cisco? do i need to install?
thanks,
Nyi Nyi
Hi,I'v two networks with the same addresses. i'v been ask to find a the best way to connect them together without the use of a NAT.And both of them will talk to an out side source...Can some one help me????? Regards, Michel Vaillancourt
My client is planning major Active Directory structure changes. They are presently running version 9 or CuCM, UCxN, Jabber, UCCX and CER. For LDAP synchronization, they have just used the top level OU. They want to know how this AD change effects the...
HiWe are using CUCM 6.1, just wondering if the user can sync the contact between outlook and personal directory. I found a plug-in pakage named TacSyncInstall on CUCM server, but don't know how to use it. Any suggestions?Thanks. Leo
What does one have to do to get NFAS working on a 2620 via MGCP. I have 2 spans 1 d-channel. Everytime I try, it makes each span individual with a d-channel for each. Thanks in advance
Dears, I have a SIP trunk with one of my customers and he is complaining of hearing abnormal DTMF tones during the call. Does anyone have an idea what the problem might be.
