Other Collaboration Subjects

Hi All,We have VCS (control and Express), TMS, MCU and ISDN Gateway in UKbut we have also another MCU5320, TMS in Australia and using same VCS in UK as a call Control. Questions:When Australian endpoints make multiparty conference among endpoints, do...

topology ----PSTN---------------FSO--Router2800---f0/0-------------------------switch------------------------3CX serverip phone connected to the switch also  First , i am new in voice network so i ask to help me in that . 1- i cant see FXO port on " ...

CME routers C2921 are employed as the call manager in all the branches. In a branch, I configured both CP-7841 (SIP) and SP-7965 (SCCP) on the same LAN, configured dial-peers in order to call within and outside the LAN which worked well for the SCCP ...

Dear All,There is HO and Branch office. CUCM exist in the HO and Call manager express will be installed in branch office. There will be point to point line between HO and Branch. Now how i do the configuration part , so that HO can Branch and Branch ...

Hi all, Just to test a backup we restored the backup of a CUCM cluster of one of our customers in a VM. The backup went well according to DRS as well as the restore in the VM (the CUCM is still a bare iron 7825i5 v8.6.2).After the restore I went to c...

Hi There,Wondering if Cisco have a tool to convert 3750 QoS config to 3850 QoS config?  We are about to roll out 3850 switches and are in the process of converting our running config template, and such a tool would be handy.  At the moment I'm readin...

Call Manager Access Resolved I found some instruction to press I and enter the "Interactive" mode after a reboot. I could not get the procedures to work because it scrolled by so quickly. I hit the "Scroll Lock" and that slowed things down and allowe...

Hello all I am in the process of rolling out MRA for our organisation and since we have an existing WebEx Messenger service that users are familiar with and use extensively to communicate with partner companies I have decided that a hybrid MRA soluti...

Looking for the right firmware to load on CME 10.5 in preparation for the installation of ATA 190. 

First off, Please read fully.Second off, I don't have a lot of experience with cisco IOs.I have a cisco 2821 that all our voip and fax calls get routed through. Can I setup the 2821 to automatically detect which incoming calls are fax calls and autom...

Dear All , i have cucm 10.5 which has ICT trunk with other company CUCM 10.5 too ,we have site code 66.XXXX on each site and All calls to and from is working fine , Except when the SNR working . when ipphone from Company A , called IPphone in Company...

Hello,I am having BE6K CUCM, CUC and IMP version 10.5.X.i am looking for solution in system with that if any changes happened to current running configuration, system should provide the notification to admin user.would be this setup possible with in ...