I need give quality of service my STUN traffic , but , my config not function :This is the configuration :! class-map match-all voip match ip precedence 5 class-map match-any STUN ...
I have a 3660 with FXO ports connected to a PSTN lines in mexico, I can finish calls perfectly, but when I make a call and the called side (PSTN) terminate the call first, the FXO port do not close the connection and still active until I disconnect t...
I am helping a customer with two 3.1.5 Unity servers at the same location, homed to the same Call Manager. The customer purchased a 12 port VM server and a 4 port UM server, becuase you can't have UM and VM users mixed, and Cisco won't sell a Unity ...
Hi there, this might sound like a stupid question, but I have a smallproblem with my VoIP. I had it working until I tried to split the call manager, my gateways and my IP phones into different VLANs.From my Call manager I can Ping all the elements i...
Dear all,I have 2 ip phones, they can communicate with call Manager in different subnet & 2 ip phones can talk together (in same subnet).But I can ring to another ip phone & hearing remote voice, the remote user can not hear my voice (one way communi...
I want to connect the central office over two parallel 2 MBit/s E1-Link with the branch office. The voice traffic should be prefered, but should not get the whole bandwidth in worst case. Is it possible to put the voice data in the high priority queu...
We are going to implement Post Routing with a Rockwell ACD, and was wondering if anyone had any experience implementing. Unfortunately I do not see and ACD Supplemental Guides for the Rockwell that may assist. I've done this before with an Aspect A...
First thanks for this site. I have found the answer to almost all of my questions right here before I even had to ask.My questions are simple ones. #1I have read all the posts about upgrading but I have yet to read anything about an upgrade from 3.0...
My CM and 2620 gateway router are on one vlan and my data is on another. The 2620 is the dhcp server for the IP phones only and I have a dhcp server on the data vlan providing addresses for the computers. Most of my phones are working fine but some p...
Hi there, I'm wondering if it's possible to place calls between a Cisco Softphone and a Cisco gateway (any model from 827 to 3600 with analog voice modules). So far the only answer I've seen implies the use of CallManager which unfortunately I don't...
