Other Collaboration Subjects

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Forum Posts

FXS analog phone can't break dial tone when pressing some number keys.

Hi All,May I know how to break the dial tone when pressing any keys? I've tried to set the input gain to 0 dB, -1dB, -4dB and 4dB but same results.Voice-port also configured  in "timeouts interdigit 3". In other sites, same configured but it is worki...

VIC2-2E/M E&M card and delay. Using with Motorola Astro Modem

Hello, I am running a proprietary modem  signal across  Cisco VIC2-2E/M cards (with microwave for transport). 4 wire circuit.The modem is a Motorola Astro Modem, it runs constantly. It is connected to a Motorola Quantar radio base station on one end,...

Cisco UC 9.0 NFR - UCCE License ?

Folks, With the release of the Cisco UC 9.0 NFR kit, I noticed that it shows "No License Required". On the 8.5 NFR Kit there were "NO" Cisco Agent Desktop Licenses issued. On the 9.0 NFR release the notes read "No License keys Required" (See below). ...

saship by Beginner
  • 2399 Views
  • 4 replies
  • 1 Helpful votes

DMP 4310 UNC/Network Access

I have a DMP 4310G and wonder whether there is any restrictions for UNC network share access. I have a FlashLight 3.1 AS2 SWF and it won't connect to the data file on the network share if it runs from the DMP. The SWF file is copied to the DMP usb_1 ...

sharpgate by Contributor
  • 588 Views
  • 1 replies
  • 0 Helpful votes

Deployment Question

Running into a situation that I need some clarification on.Scenario:in  a 5.2 environment and 4400G DMP'shave deployed a presentation to  the DMP and have issued a Local command to have the DMP play from  local.I then go back into the presentation an...

Resolved! MXE Download Links Fail

On the MXE 3500, after uploading and converting a video, the Download links fail with the following message:Error 349 (net::ERR_RESPONSE_HEADERS_MULTIPLE_CONTENT_DISPOSITION): Multiple distinct Content-Disposition headers received. This is disallowed...

jacobmumm by Beginner
  • 464 Views
  • 2 replies
  • 0 Helpful votes

DMM Upgrading to 5.4 failing

Has anyone else seen this.Have a 5.3.0 DMM installed on UCSSetup and licensed and workingI even did a fresh install of it.Put in the 5.3 -> 5.4 upgrade CD  (yes checked the MD5 and it was a good download).AAI - Started the upgradeMounts the CD then I...

marc by Beginner
  • 991 Views
  • 7 replies
  • 0 Helpful votes

CCA 3.2 installation Windows 7

I am trying to install cca 3.2 in windows 7 - 64 and too late did I check the release notes that there was a bug. The error message is          JVM not found       The workaround is below, however I clicked on the other option that popped up to re-in...

johnhsnow by Beginner
  • 639 Views
  • 4 replies
  • 0 Helpful votes