Other Collaboration Subjects

I have two routers for VoIP purposes. One of them has 12.0-4T IOS and the other one has 12.1-7 IOS. That is why I use the "codec g729r8 pre-ietf" on the adequate voip peer of the newer software release router.If I initiate the voip call from the newe...

We use AS5300 for VoIP with ISDN signalling.We want to block incoming call (call from PSTN to AS5300) and allow outgoing call (call from AS5300 to PSTN).What should we add in our configuration?Here is our config:controller E1 1 pri-group timeslots 1-...

A MC 3810, connected via LAN with a 3600 Router, the MC3810 is connected to a PBX trough FXO interfaces, is it possible to place a call, from Router MC3810 to Router 3600 via LAN Interface ?------ ------- ------|3640|---LAN------|MC38...

Is there a way to set/get cumulitive or max counters on an IP telephony gateway? In this case it is a 2600.

We have a Mitel iMagination PBX with E&M cards and I want to connect it to the E&M cards in our 1750-4V routers.Do you have any known working cable pinouts and any suggestions for the options to select on the Mitel PBX for best operation with the VIC...

In this scenario there is a T-1 between a 3660 and a 2611 that all data and video conferencing travel across. There are video conferencing problems if a large data file is being transmitted. What is the best QoS method for this.

What are tcp/udp port numbers of the h323 protocol to be measure for netflow application.

Customer used to install VoFR in old network. Now they install new router in new plan , using ppp network. They want to combine VoFR and VoIP.How to achieve this.

When CallManager is integrated with Octel PBX, Choppy voice can be heard. What could be the reason.

VG200 with 2MFT-T1 card, provisioned and configured for local and second T1 for Long Distance service, experiencing echo on all calls, QoS is enabled on VoIP side of the voice network.

2621 is connected to Frame Relay and want to prioritize voice traffic going from Ethernet0/0 (other data traffic goes also via Ethernet 0/0)(using IP telephones or other IP gateways, which supports IP precedence)Which type of queuing should we use (a...

How to figure out to setup the SC2200 for ascending | descending order, to prevent GLARE.

Garbled voice is heard when using the transcoder on the ws-x4604-gwy. The garble is heard when transcoding from 729 to 711. The party that hears the garble is the party that is in the 711 region.

Manual indicates voice can be compressed at 26kbps using g729. checking with an analyzer, it showed at 56kbps. What is the min. and max. compression rate and how to configure it.

From the Engine Page in the Apps Administration the JTAPI sub-system appears as OUT_OF_SERVICE.