Other Collaboration Subjects

Hi everybody, I've a AS5300 gateway and I'm recieving traffic(calls) from other carrier, now I'm billing that calls with the syslog but I have downloaded the acs of cisco. My problem is that I don't understand very well how to configure that acs eve...

I want to upgrade the UNITY from 3.0.2 to 3.1.3 but fail.<br>Before running setup.exe program in unity 3.1.3 CD, I did following patch installation:<br>1) NIMDA patch<br>2) SQL SP1 + hotfix<br>3) reinstall IE5.5 SP2<br>4) MSXML SP1 <br>(anything miss...

Does anyone know how to disable the call waiting beep in Call Manager 3.13a? Can it be done on a per phone basis?

I have installed unity 3.1(3), integrating that to an existing exchange 2000 server. I have installed all the listed patch and the hotfix. I am using sql 2000 server as the ports are more than 32. The problem i am facing is when i hit the pilot voice...

Hi,I need to know what cisco interfaces I need to connect two PBX Siemens with a Cisco 3640 using a E1 trunk between the cisco and the PBX.Also if you know which IOS I need.Thanks,Rodrigo

In a IP telephony call, how much bandwidth is typically used for the skinny protocol traffic control? I am setting up QoS for the control protocol and wondered how much should be provisioned per call?Thanks in advance

Has anyone sucessfully implemented a 7900 series phone over a VPN 3002 Hardware client to a 3005 concentrator or PIX. If so how? I can only get one way audio from the 3002 side. I have tried using the 3002 in PAT and network extension mode with IP Ph...

Hi, I have implemented CAS with a E&M Wink-Start signaling on my 3640 router to a PBX that I have. After implementation, it works half the time. When the call fails, what I see is that same call uses different channel for send and receive when I us...

On the C drive on our Unity machine disc space is dropping (50 mb in 7 days) for no apparent reason. We are now down to about 30 mb free. Nothing is on this drive except Windows 2000 and the SQL server. Unity itself and all other applications are on ...

Is it feasable to deploy AVVID over a cable infrastructure using ip phones through cable modems through a CMTS? What are the drawbacks? I know for one that inline power doesnt seem feasable. Thanks.

Dear Sir, I am very glad, that u are reading this message. I purchase 2 router that is Cisco 1751 -4V , with E&M module now what happen I connect that those with my PBX it is working fine any time I want to connect to another side it is very easy … ...

We have remove Unity 3.13 from a ex5.5 site. This was ungraceful. The Unity folder and the old ex5.5 still exist in the ex site environment. There are no mailboxes on the Unity server. I can simply delete the exchange-Unity from the Ex site...How d...

Hi, I need to set up a call forwarding in which a PSTN call to a certain extension will be forwarded to a home number. How could it be config in CM or Unity ? Thanks for help.Duc Vu

I hhave unity 3.1.1 integrated with Rightfax (I can't remember what version). When I log in, it announces, the number of messages, then the number of voice messages and emails, but does not announce the number of fax messages. What am I doing wrong...

Hi alli have bought the 2 ATA 186 in my officei configred on at NY and on at TXiam able to call using account of D3 from both the office, when iam trying to call from ATA 186 NY phone to ATA 186 Phoneiam getting busy tone, iam not able to call estab...