Hello!Please, can somebody tell me, which filesystem the HDD of the Cisco HD DVR 8485DVB Receiver has? Are the recordings encrypted?Thank you!Kind regardsRichard
Hi all, I need your valuable suggestions how to design a network of voip using voip.Suppose there is a Site A and Site B and you are using different service providers and creating different vlans in each site for voice and data.Lets say it...
I have 2 DMP4305G, when I connect the playres to the network in the DMM appears in status up, but after a few minutes the status change to down...... what i can do??? thanks for your help.
We want to group DMM users such that they only have access to content, presentations, and playlists that belong to their group. Is this possible in some way. Perhaps I'm missing something obvious?Thanks in advance, -Dave
Hi. I'm a junior engineer in Korea. I have a question about DMP 4310 with creating a folder of internal storage.I can acess the internal storage but, I cannot make a folder or file uploading.I already checked about Access mode - read and write, and a...
Hi! We have single DMS system with cast module. Can we extend our license to add a signs module at later time? Or we need to buy the whole new licenses (cast+signs+dmp's ones)?
Hi,It's been a while since I deployed any new voice routers, I have a need for 8 BRI ports on a new router, do I need a PVDM DSP chip for this? I am looking at a 2901 with 2 HWIC-4B-S/TThanksJon
Hello all,We have Meeting Place 8.0 on Express Media ServerWe have a problem that when a participant in the specific meeting leave that meeting and try to join it again he failed to join?Is that ordinary or there is an additional configuration to sol...
We have a new MeetingPlace/WebEx node integration that went live yesterday. Most users are OK, however, this morning we have several users that are receiving an error message when trying to log in (for the first time: "Auto Account Creation Failed" m...
I have connected an ELO 3200L touchscreen display to my 4400 (5.2.2) device and the touch control doesn't work. The dmp detects the display and is listed in the DMP setup but touchscreen functionality isn't working. Can any provide some assistance?ht...
Hi,I wonder how is possible using an ad hoc videoconference showing in my ip phones and softphones all participants simultaneously in reduced size. I've seen this feature enabled, but I wonder how to enable, wanted to know if I need any additional ap...
1) I notice in the data sheets, CTMS is listed but not TS 7010 or MSE 8000 support. Is that not supported right from the get go? I can understand for legacy CTS end points since Cisco had CTMS and Tandberg had TS/MSE there was a roadmap to cross inte...
I set up a presentation using the DMM. Each presentation has a zone that cycles various types of content, for example, image objects, flash objects, and video objects. I am currently serving all content from a server out side the DMM, and I use a red...
Is it possible to construct a playlist, with Presentations as the objects within the playlist? Surely this must be a no-brainer, right?I want to loop...DO FOREVER 1) Play presentation #1 for 30 seconds, then... 2) Play presentation #2 for 10 sec...
