HI All,I am having issues with my DMPs acquiring an IP address from a network that is DHCP enabled, I have tried to reset the DMPs but the situation seem to be the same thing..I would appreciate any favorable response... Tolu
helloOur company has purcheased the Cisco Digital Media System. We need centralized management of all DMPs. The server is : DMM-SVR-C210-K9 and software is DMM NFRV5.2 Perptl The problem is that I can install that sowtware on my server, the error is ...
Hi all,I have CUCM, Cisco Unity Connection, Contact Center Express. Contact center express is used for routing incoming call to group of agents, if there is no agent available then the call is routed to Voicemail. The agents need to be notified by MW...
We want to integrate CallManager 7.01 and Exchange 2010 UM. The plan is to build two Exchange 2010 UM servers. Who would be resonsible for load balancing (messanging) between the two Exchange 2010 UM servers? CallManager or Exchange? Does anyone ...
Cisco IP Phones registered to CUCM 8.5 are able to keep 100 records for missed calls, received calls and placed calls. Is it possible to reduce the number of 100 records to 20 records?
Hi,We are running CUCM 6.X. Recently i add Nokia Call Connect Client trial ver on my Nokia E72 Device and was able to register to our Call Manger.But now i want to add Nokia E72 device as a SIP device to my Call Manager, but its not getting registerd...
Has anyone setup a single zone ValCom paging system to work with an h323 gateway? I was told by ValCom to use an FXO port according to the ValCom procedure I've attached to this post.Dialing the extension causes the lights on the FXO to light up, so...
Hi all,In our enterprise, Windows CA is being used and we are having problem using Windows CA with S&S. Windows CA is not accepting the CSR we generate from S&S and gives the following error: http://support.microsoft.com/kb/312344Your certificate req...
When I call inside... FXO-M1 card get Caller ID number ... but I still have message: "From Unknown CallerID"...Is it OK? Or I have some other options?Thanks in advance.
Is there anyway that I can create a job that will import client mattercodes on a nightly basis so the customer does not have to open the web page and go thru the process.. I just want to run a nightly job that will import a new csv file
Is there anyway that I can create a job that will update client mattercodes on a nightly basis so the customer does not have to open the web page and go thru the process.. I just want to run a nightly job that will update a csv fileTks
I just put in a new 7970 phone and the time and date are incorrect. Does anyone know where to change this? All other phones, 7940 and 7960 are correct.
