Other Collaboration Subjects

I'm trying to setup an audio conference on a Polycom MGC100 with a Cisco Ata186. I can dial out to the Ata using the IP address and the Ata will answer but it disconnectes after 30 seconds. Has anyone else tried this and if so what were your results?...

Some days we get busy signals when users are calling into certain departments. Besides the Dialed Number Analyzer is there a log or something that shows me what the call is doing when it comes into callmanager?

Anyone get the IPPhoneStatus xml to display on a 7921 running firmware 1.2.1?I can get the image to pop up on 7961's and 41's. I don't have a 71 to test with right now. Since the 7921 is a color display figured I would try ipphonestatus file without ...

I've been working with one of my web guys and we can't seem to figure this out. I have three images that I want to rotate thru on a 7960 phone via the idle url. I'm using the code below to pull up an image. According to the Cisco documents, I should ...

Greetings, am working on a program that is supposed to monitor lines call activity and save it for later usage,i can catch the events really well now using ATAPI.Net, but i was wondering if i can get the route partition of the line that initiated the...

Hi experts,,When I configured IPMA with CCM 4.2 everythings look good, but the filtering down message appear, and when I configured the exclusive filter it does not work. PLZ help.Thanks..

Some of the phones in my cme has different times. Why can this happen? Doesnt all the phones get the time from the router?Another question is can the phones get time from an ntp server?Also there is cue in my router. I think it gets the time from rou...

the console attendant is showing "?" next to all users, any idea why this happening?

Hello Gurus,Im new with this kind of setup, my company buy a Cisco AS5350, and my task now is to configure to comply with this kind of setup.Caller --> VOIP provider sending DID --> Internet ---> My AS5350 --> PRI E1 --> TelCo Phone switch ---> party...

I'm trying to a simple CUAE application (using the designer) with a SendExecute. Whenever the SendExecute runs, it fails and the following is placed in the log: Phone was able to process request, but replied with an error: <CiscoIPPhoneError Number=...

I cannot figure out why my Voicemail option shows "Failed to connect- Server Unreachable" when I can connect to Unity7.0 just fine and ping from my laptop that runs UPC. I login with the same ID/pswd on the Accounts/Preferences - Voice Messaging loca...

I'm using Cisco IP Services SDK v4.1(1) and CallManager version 4.2(3) and 4.3(1) and a web server with MS 2003 server and IIS 6.0I have changed the authentication variables in the .asp page to match my environment.When I access the push2phone.asp pa...

i have a CCM 4.1 and MGCP Gateway. so can't implement blacklist by ios command. can i write a JTAPI application to implement blacklist?