Other Collaboration Subjects

I am running CCM 4.1(2)I have several receptionists that use attendant console. When anyone of the receptionists log into AC call control comes up. When they try to transfer to users in the directory they all get the "Failed to transfer due to inte...

Hello, I have a AS5400 - and I would like to configure a VoIP dialpeer with username/pw (pretty much as if the router was a phone)Is this possible ? I have been unsuccessfull in finding information on cisco.com about this, so if anyone could point me...

I have on a 3750 the following configuration for QoS for IP Phones. class-map match-any QOS_VOIP_SIG match ip dscp af31 match ip dscp cs3 class-map match-any QOS_VOIP match ip dscp cs5 match ip dscp ef policy-map VOIP_QOS class QOS_VOIP priority 2...

Hi have a number of phone that are not registered how can I forward these to VM or another number? I can't change the busy / call forward all or no answer settings?thanks

Only question . What factors can influence that a fax call international don?t function , but national function ???In this case , the conecction is FAX over IP , between two points national . The analog part is international , but the FAX over IP i...

Hi,For national calls the customer would like to dial 0020xxxxxxxx, where the 1st 0 is the digit to establish an outgoing PSTN call and 020 is the city number.Based on below configuration, it's only possible to make an outgoing call with 020xxxxxxx t...

Hi. Currently I have a CallManager cluster providing services on different cities. Now we are moving a new office to the IPT cluster and the city dials 7-digit local calls dialing within the location and 10-digit local calls and 11-digit LD, etc..Wha...

Hi,Where can I locate IPIP gateway information/configuration on the cisco.com/univercd siteThanks

Hello Guys,When I dial our main phone number (212-586-1780) It rings only once and my phone shows it's connected but on the other end nobody hears the phone ringing. This is our main number for the outside callers and has to ring on the extension 370...

i am pretty new to the Voip....so just have a logical question..... i have 2 sites with 2620 with each side....now if i get adsl and put a adsl module in the router and get a static ip from the isp....and at the same time get an FXS card and putit as...

Sorry, I'm a complete VoIP novice...We have a bit of a weird problem in that when you dial an extension which is our other office (connected by 2 x 2mpbs MPLSs) the caller can hear the recieving person's voice but the the recieving can't hear the ca...

I'm lookin to change the endpoint DSCP marking for signaling from AF31 to CS3 on the 6608 module. Does anyone know how this can be done on the actual gateway itself or through CallManager? I've verified the CCM Enterprise Parameter for Call Signali...

Im trying to change CUE license and get the following errorOnline install/download is not allowed due to insufficient FLASH capacityWent through the whole boot helper process and it installed a default CCM license Im trying to change this to CUE any ...

I recently added a second Sub to my cluster. Everything is fine, except I am getting RTMT alerts that directory replication failed. Also, when I run DBHelper, the recently added CM is not shown. I confirmed all host settings on all three servers.R...

what VWIC can be put in NM-HD-2VE? thanks