Hello, I know that QRT feature requires Cisco Extended Functions service.My question is:Which other CUCM feature depend on / require Cisco Extended Functions to run? ThanksPiotr
Forum Posts
Hello All, I am attempting to register a 79xx sip phone to a Avaya Session Manager that requires third part TLS certs. Can anyone tell me how to manually add the certs to the Sip Ip phone? Thanks
hi everybody,i see most people continue their pro career in security or data-center courses after completing routing-switching,and also most employer post job offer for security positions, what about collaboration?is it logical that we focus highly o...
Hi,I have a customer leveraging FAX detection (Incoming call via SIP, the old ISR39XX looks at if it is a FAX call or not and routes to Right fax if it is a fax call or to CUCM if it isn't). However, it seems that this is not supported the 4000 platf...
Does anyone know where to find Visio stencils for Cisco Webex Devices (Boards, Room Devices, etc?) I checked the Cisco Stencil site and do not see any current Webex VC equipment listed in any of the libraries... https://www.cisco.com/c/en/us/product...
Hello Everyone. Im a little new to the whole Cisco Expressway deployments. Have some general questions if anyone wants to chime in.In my environment we are replacing CIPC with Jabber Multiline. We have the new Jabber 12.X and the cop file installe...
Hi guys, I have a quesiton about RFC 3264 and implementation on CUCM. The SIP negotiation call seems to be correct, the call come from ITSP to CUCM and send to IVR, it seems to work. But when the call is redirected to a phone they don't have audio fr...
Any software can do the conversion by providing Genaral timestamp to Unix Epoch Timestamp?
Running Jabber 12.6 - The "Connect to Device" option, from what I understand should allow me to connect my Jabberto my Cloud Registered DX80 using proximity. My Webex Teams app can connect without issue, however the Jabber eithercannot find the DX80...
Hi Cisco Community,May be a bit off topic as neither of these are Cisco products but I was wondering if anyone in the community has any feedback regarding Voss or Kurmi? Our use case would be automated onboarding/offboarding (CUCM and Unity), Number ...
Does anyone know how to decode QSIG Facility messages indebug isdn q931 output? ISDN Se1/0:15: TX -> CONNECT pd = 8 callref = 0xE211Oct 20 10:09:39: Facility i = 0x(.... hex value ....)Tnanks,Andrei
Looking for suggestions on a stand similar to the one pictured in Cisco Boardroom of the Future. We need to position a Quad Camera below a projection screen that is directly in front of windows. Looking for something that will not move and only be ne...
I have 2 PBX systems, both running with analog and digital phones. They are separated with a series of L2 switches. The PBXs have a VoIP NIC which connects to the network at access VLAN 10. It runs at SIP and RTP voice protocols. Phone end points fro...
Hi Forums, I have an issue that is no new issue, and there a reasonable amount of data on out there, though I don't believe much usable data. I've done several days of googling, and have done quite a lot of reading prior to posting here, with the hop...
I need to scope monitoring for my solution, I investigated prognosis and netiq many years ago, can anyone provide any other potential partners-we UK based Thanks
