Other Collaboration Subjects

Hi,we have two router configured to do sip-ua a Cisco2811 and a Cisco2611XM with voice module. Everything works well on registration behaviour but when we try to call from external on the first router (Cisco2811) the call is refused with message "SIP...

Hi,I need to create more 15 rules in a voice translation-rule but 15 is the maximum number. What can I do to creat more?Thanks a lot...RegardsCed

Hello,I have CM 5.0 installed, and am using a 2811, with BRI to act as a PSTN gateway, using MGCP controlled backhaul of BRI signalling.However, I also see the option in CM5, to use SCCP for gateway configuration.Can SCCP be used on a 2811 for PSTN a...

Hi is there a way to reset all the phones each night, using a KRON policy on the router > telephony-service > reset all ?REGARDS

Hi, recently I have had Cisco Call Manager with Unity and IPCC installed in our Head Office. We have over 100 remote sites with various telephone systems. I have imported all sites in our Call Manager Corporate Directory as users to allow the Head Of...

I have some users that just want to be able to monitor other's extension status. They only want to be able to see if they are on the line or not. They don't want their phone ring, flash or do anything when calls are made to those extensions they are...

Is there a way to add a system message to the phone display when using CCM like you can do with CME? On CCM it reads - Your current options just above the softkeys. We would like to change this message.Thanks,

hi,I have 7960, 7961 phones in the same Voice VLAN. And I have also an Non gateway controlled Intercluster Trunk between my call manager cluster and a remote call manager clauster. the both clusters are on 4.1(3) version. With any 7960 phone call set...

Hi,Does anyone knows how we can make a number unavailable between 17.00 and 06.00. I have to create a number with a permanent forward to cell phone, but the number should only be called between 06.00 and 17.00. So if you are dialing this number at ...

Hi All, I managing the Video conference setup but I am struggling to find a appropriate IOS for GatekeeperI need some suggestion for selecting router series (Is 2620XM is ok?) and also the appropriate IOS?Gateway is TandbergPlanning for 8 video confe...

Can anyone tell me whether it is possible to integrate CallManager to Active Directory Application Mode?

I have test environment which contains: CCM 4.1.3 and Cisco 2851 (C2800NM-ADVIPSERVICESK9-M, Version 12.4(4)T) which acts as MGCP gateway and SRST device and 2 IP phones 7940 and 7912.Both phones are in the same device pool.When I'm disabling CCM, Ci...

Does anyone know or have the old PDF on the CDR Database file spec that was on cisco? With the new website redo that doc seems to have vanished. The developer site has links that go to general ccm doc page now also.

Does barge and cbarge in ccm 4.x require media resource, either software or hardware or use built in dsp in the phone?

Hi All,I'm running CCME 4.0 and CUE. Phones are currently running SCCP and work fine. I've upgraded a couple of phones to SIP but am having trouble getting to VM. I get prompted to enter my password but CUE doesn't seem to recognise that I've entered...