Other Collaboration Subjects

Hello Folks,In our CallManagers and Unity servers, the CSA doesn't allow the McAfee VirusScan get updated. Everytime I need to update the MCafee have to stop the CSA service and update the McAfee. Is there any way that I can ajust the CSA in order to...

Hi,I'm trying to get the backup working in version 5.0(4), i know sftp server is setup correctly since I can connect to it using a client. From the callmanager i just keep getting unable to access SFTP server, please check path and credentials are co...

I am in SRST mode and cannot gain access to the PRI.I am able to dial to the numbes associated with the PRII have the following commands in the fallback config:access-code pri 9 direct-inward-dialsecondary-dialtone 9Also, incoming calls

I'm a begginer using Cisco XML for application development. I just did a simple menu <CiscoIPPhoneMenu> that is working great into the Emulator. But when i use the hardware phone to get the page is shows directly the XML itself like a notepad. The me...

A few weeks ago I posted a question reagrding SRST & MGCP with FXO Ports. The reponse to my post was great and the new configuration worked. However, it appears the command that I need to be applied on the dial peer gets over written when MGCP is do...

Hi allWhat may be the general daily routines or general problems faced an cisco ip tlephony admin regarding call manager,ip phone,voice gateway in an organisation which implemented cisco ip telephony

We have the requirement to use ad-hoc conference as an emergency bridge. Is it possible that can set up the system that once the authorized station dial the conference number 888 (or press a button) that would alert 14 other IP Phones and these 14 st...

Hi Team,I know this topic itself is a book and I too have gone through SRND guide specific to CCM 5.0. But from your expert point of view need to know what one need to consider when VOIP is going to be implemented and existing TDM setup needs to be r...

we're using a 2801 router with mgcp for bri interfaces and fxs interfaces.When an analoge phone is connected at the fxs port, it's working fine. A fax or modem is not working correctly. sometimes it's okay, but most of the time is lost the connection...

I had several electrical problem for about an hour powering down and up the router for about 4 or 6 times, after that the router restart to work as normal but the AIM Unity Express did not start as normal. I have a message that is trying to recover ...

I would like to be able to access a corporate phone directory that is kept in a SQL database using the Directories/Corporate Directory button. This would be used instead of the CM Directory only for phone number lookups.Two questions:1) is this feas...

Hi forumI have a T1 PRI using H323 GW.Can I setup a DID so when people call me call is redirected to another dial-peer POTS as outgoing?POTS -- GW -- POTSIs this possible? No CCM nor CCME.Thank you

Hi folksI am currectly rolling some new 7941's for a client, the callmanager ver is 4.2(1) with sr1b. Anyway they only want people to be able to use the default ringtone on the phones, currently users can go into prefernces and hit rings, in there th...

My question stems from a problem that we are having when switching from speaker to handset, and handset not picking up immediately. When on the speaker phone, and the handset is taken off-hook, the voice does not transfer, rather it continues to use ...