Other Collaboration Subjects

Just received my call manager cd's today and found that the CD's are OS version 2000.2.7a yet the documentation refers to 2000.4.1. I've tried using the HArdware detection disk on the server (HP DL320 G3) and it reports the hardware is unsupported. ...

Hi I have some weard port utilization. My CCM (tftp service is active) is trying to communicate with an IPPhone 7912 on UDP\15448,UDP\11787, UDP\6633 or UDP\2201. Do ou know why ? That's append when the end user try to change the ringtone of his 7912...

I am in the process of manually summarizing some routes within my network.Which of the addresses below would be included in the manual routesummarization of 153.25.200.0/21?A. 153.25.198.0B. 153.25.206.0C. 153.25.208.0D. 153.25.224.0Should not the an...

I had a customer say that two fax machines, one on each port of the ATA-186 wasn't recommended by cisco This is ATA-186 SCCP with Callmanger 4.1(3) and H323 gateways with fax pass-thru on the dial-peers. Can anyone say if this is true? Another cus...

Hi,I try to install Cisco IP Telephony Security Token on my callmanager but I have an error message.I have activated the Cisco CTL provider service and the Cisco certificate authority proxy service on my callmanager.The Smart Card service is set to s...

Is there support for fractional PRI using MGCP with any version CCM and any type IOS gateway? I know there is a service parameter that blocks out timeslots but I understand that this is not supported for production and plus it's limited to 5 per clu...

Is there a way to register more than 34 7940 phones register in SRST. SRST 3.2 on 2851, the max-ephone is 96, however the limit-dn for 7940 is 34 and can not be higher. Any ideas?Also, I can get 7941G devices register in SRST, but not the the 7941G...

We are running CCM4.1(3), with a dedicated MoH server running multicast.- User A call user B and put user B on hold, user B can hear music (OK)- User A call user C and put user C on hold, user C can't hear music (NO)Any advice? Thanks.

Hello The redial button (on 7940) doesn't remember the last numbers of the dialed call. Do I have to configure an option on the ccm? Drive me crazy. thanks

This is a strange one. When calling from the phone using the speaker, the call is completed fine. During the call if the handset is picked up, then the call will drop. This is not an everytime issue and has occured on both a 7940 and 7960 phone. ...

I have a 2801 as a cme and when I make a conference between two pstn parties and a local user, the conference is fine, but when one of the participants is a remote phone in my wan site, the conference can not be completed. I assume this a codec issu...

Good day, is there ANY way to have calls in progress stay up during a transition to SRST mode?

I have 2 H323-Gateways, each with 1 E1-Interface to public network. The 2 Gateways are in a route group with "top down". If the E1 of the first GW in the Route group is disconnected, there is no overflow to the second one. (CCM 4.1.3 SR2)Any ideas?