Other Collaboration Subjects

Hi,I am getting an error "Session timed out..." whenever I try to add a new user. Anyone can advice me, how to get over this issue. I am using CM 4.1SR1 .ThanksBrgdsrenzil

I have multiple sites with Cisco 2811 routers installed. How can i use SRST aggregation to give me support for more than the default 36 IP Phones on the 2811 router?

Does anyone know if there is a way in CCM to redirect a dialed call to a service? What I'm trying to do is if a caller dials 411, redirect them to a web based tool rather than paying for directory assistance through the telcos. Any ideas? Is th...

I am having some issues with static and hissing on a PRI.The Gateway is MGCP and I have checked the following:1. "no mgcp vad"2. Obviously there is no VOIP dial-peer with MGCP so no place to put "no vad"3. Silence Suppression disabled on CCM side.Ano...

Hi all, I've got a strange behaviour (I think). We're running CM 4.1.3 and external lines are 4 FXO-ports.I've got a Route List and Route Group with 3 fxo's and a RL/RG with the other 4th FXO. I want phones to call out using the 3FXO-RL and a fax to ...

How to change the Numbering Plan? is it something while installing? that we cant change after that from "North American Numbering Plan" ?

I am upgrading a 400 user office from CallManager v3.34 to 4.1I will be using new hardware for the install. Is there anyway you can backup all of the user specific things - speed dials, address book ,...and then have it migrated to the new server? I...

I have 10 elevators that use an analog dialing device with no handsets. After a call is placed there is no way to hang the device up. After the call is terminated the speaker will start sending out the "reciever off hook" tone for up to 3 minutes be...

Hi. I'm trying to verify how many CTI Ports are in used concurrently. I'm trying to have perfmon configured but on the CTI Manager counters I can't see what I'm looking for. Is there a way to see that in real time??Thanks in advanced,-Jose

I'm monitoring a CCM cluster through the CallManager Serviceability application and have noticed numerous occurrences of the following error…Directory connection failed .Monitored precanned object has value of 0.Has anyone seen this before or know ex...

Hello.I am having an issue with a 7940 (running 7.4) in which it will stop taking invite requests and respond with 486 - Busy Here even though the phone is not in use. Rebooting the phone corrects the issue.Upon debugging the SIP state, I am getting...

Hello,I have a connection between a PBX MD110 and a Cisco router C2851 running MGCP. I have Slips errors all the time, counter is increasing every few seconds. Calls are working well but I have a lot of errors. The MD110 is configured to supply the c...

Hi, I am having an E1 terminated in Cisco 3745 NM-HDV2 card. but only 15 channels are usuable. channels from 16th to 30th is not working.can anyone help me out from this.Regards,Gautam