Hi all,I have question about dial plan on routerwith CCME and BRIs instaled on the samerouter. Is it possible to use 4 BRIs on router with CCME and configure dial plan to route outbound and inbound calls through these 4 BRIs? If yes could someone giv...
We have installed Emergency Responder and upload ALI information to SBC. When calls are routed throug CallManager the PSAP has the correct information. When the call is routed through ER the PSAP only has the billing address. We did a debug during a ...
In my CAR reports have all callsthe QoS Information "NA".Where are the issue off this behavior?How can i resolve this?
my unity 4.0(4) was crashed. since i reinstalled with backup i was having, i m not able see any indication on IP phones when any new message received immy mailbox.there were few phones for those red light was glowing before unity crashed. when i chec...
Hi,Is it possible to use g729 for voicemail access across the WAN using CUE ? My setup is as follows Site A ( CM cluster + IP Phones) - WAN - Site B ( CUE + SRST + IP Phones )ThanksBrgdsRenzil
We are looking at options for a deployment where the customer has a Avaya PABX and connected to the CCM Express. We are looking at providing an Mobile IP Phone which would support SCCP/SIP (to talk to the CCM Express) and also can be used as a mobile...
Is there a document that details the specifics of the IP Phone Ports on the back of the phone? Like the SW port is it actually a switch and how are its pinouts? If its actually a switch port why does it not need a cross-over cable unless its alread...
My users reports some poor voice quality calls from PSTN. So i would troubleshoot this. In my cmr dump files i see only jitter values from 60 to 105 on connections from ip phones to my voice gateways. In all other cases this value is zero. How must i...
I have ccm 3.3(4)sr2 and Cisco Routers 2811 and 2801. What can i do in the CCM to support the 2800 series with MGCP.Do i have to upgrade to 3.3.(5)Is it valid to upgrade from 3.3(4) to 3.3(5)
I have been banging my head against the wall for the past three daays trying to get voip to voip calls to work over a n AS5400HPX. No matter what I try with regards to dial-peers, I cannot get an incoming H323 call to call into a SIP-server.The call ...
Is it scenario possible:SiteA 7960-->CME--T1--CME-->SITEB 7960 Can I set this up so that ip phones in site A registers with CME in siteA. If CME in siteA fails, the phones will register with CME in siteB across the T1 WAN link. The reverse from siteB...
I have configured mgcp fall back and it seems to work fine, with the exception that I cannot access voice mail.Under call-manager-fallback. I have voicemail <my vm number>. When I push the message button, I get a reorder tone.If I change the voicemai...
There are two secertaries need to answer two excutives when phones ring at the same time. Two excutives share two secertaries.Orginally, I configured two excutives' extension at two secertaries's phone (share lines). They complaint that it is too c...
Hello all, using IP Communicator 1.1(4) under Windows XP SP 2 I am noticing some very odd behavior. When I use Communicator over my HP laptop's wired connection, no problems. When I use it over the laptop's built-in wireless, the phone boots and re...
Hello. I have several PRIs that terminate in 2610 or 2801 routers. IS there a way to use SNMP montitoring to graph channels in use/free? Thanks!