02-03-2003 06:59 AM - edited 03-12-2019 10:32 PM
I configured call manager with gatekeeper
The example of gatekepper config
Zone gk1.Neo prefix 7034* priority gateway list(s):
Priority 10:
90.22.76.70:1720 Gw1
Priority 5:
90.22.76.75:1720 Gw2
If user place a call via CallManager somewhere to
7034* gatekeeper inform callmanager to call via Gw1
All is going well while Gw1 works .. But after Gw1 fails .. callmanager just gets fast busy
And dost try to call via secondary Gw2 / How to solve this ?
02-03-2003 08:19 AM
my guess..
Is GW2 available (registered). If it is not, i would guess the Gatekeeper will return an ARJ with a reason pointing at such cause. If you have a sniffer, you can clearly read that, if not, try turning on debug h225 asn1 on the GK and see what happens when you attempt a call. Another troubleshooting method would be to completely remove GW1 from the GK config and see if the call can complete using GW2 alone.
E.
02-04-2003 12:17 AM
about the second method
when i change gk configuration to v.e
Zone gk1.Neo prefix 7034* priority gateway list(s):
Priority 10:
90.22.76.75:1720 Gw2
Priority 5:
90.22.76.70:1720 Gw1
all is working well .. when i place call from Cisco IP Phone that connected direct to keyswitch (2600) not via call manager .. call redirects from gw1 to gw2 ( or v.e ) correctly
any idea ?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide