cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

122
Views
0
Helpful
1
Replies
bhoops
Beginner

Caller ID and MGCP

I had previously posted the following post and received the below answer. My question now is whether this can be changed while the ICS is active, or would if require intense reprogramming.

>Does anyone know if /when the MRP with FXO's will support caller ID running

>MGCP ..

MRP uses CCM as MGCP call agent and CCM doesn't support this for FXO.

Probably CCM folks would know if there is a plan to add this.

1 ACCEPTED SOLUTION

Accepted Solutions
Daniel Baum
Cisco Employee

The standard VIC-2FXO has no capability set for caller ID. This is regardless of MGCP or H.323.

The VIC-2FXO-M1 or the MRP3-8FXO-M1 is the module needed for caller ID. (battery reversal)

Reference:

ICS 7750 MRP Software and Hardware Feature and IOS Version Compatibility

http://www.cisco.com/en/US/products/hw/voiceapp/ps967/products_tech_note09186a008015e1c7.shtml

Dan

View solution in original post

1 REPLY 1
Daniel Baum
Cisco Employee

The standard VIC-2FXO has no capability set for caller ID. This is regardless of MGCP or H.323.

The VIC-2FXO-M1 or the MRP3-8FXO-M1 is the module needed for caller ID. (battery reversal)

Reference:

ICS 7750 MRP Software and Hardware Feature and IOS Version Compatibility

http://www.cisco.com/en/US/products/hw/voiceapp/ps967/products_tech_note09186a008015e1c7.shtml

Dan

Create
Recognize Your Peers
Content for Community-Ad