cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

332
Views
0
Helpful
2
Replies
michel
Beginner

Caller ID/CLIP on VIC-2FXO-M2

Hello there,

I've been trying to get a Cisco VIC-2FXO-M2 to see the ANI. Now as I understand from the documentation I've read, what I am looking for is CLIP, and not CLID (Caller ID). This part is a little confusing to me.

Below is the part that configures the voice port on the 2600 platform I have:

voice-port 1/0/0

supervisory disconnect dualtone mid-call

no battery-reversal

echo-cancel coverage 16

cptone NL

timeouts interdigit 8

timeouts call-disconnect 5

timeouts ringing 30

timeouts wait-release 5

connection plar opx XXXXXXXXXXXXXXX

description Analog connection

busyout monitor ATM0/0

caller-id enable

My intention is to have it connect to a ATA186 which will have a pots phone connected.

However, the calling party is never displayed, so I think I'm making an error here. As you can see cptone is configured for the country where the router resides.

Can anyone tell me what I'm doing wrong here?

Cheers,

Michel

2 REPLIES 2
wong34539
Frequent Contributor

Check whether the IOS in the router has the caller ID feature. I think that might be the issue

Thanks for responding;

The IOS releases I've tried this on are most of the 12.3 release train and a few in the 12.2T release train;

According to a document here: http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_configuration_guide_chapter09186a00800ca7df.html

it should have been supported from release 12.1(3)T and up.

Mind, I'm in the Netherlands and from what I've read a reasonably obscure CLIP protocol is used (seems to be used only in Finland and the Netherlands).

I've been trying to play with the settings to see if the caller id is received if I wait for a couple of rings. No results....

This is what the "debug vpm signal" setting shows:

Jun 25 14:50:45: htsp_process_event: [1/0/0, FXOLS_ONHOOK, E_DSP_SIG_0000]fxols_onhook_ringing

Jun 25 14:50:45: [1/0/0] htsp_start_caller_id_rx:ETSI_DTMF

Jun 25 14:50:45: htsp_timer - 125 msec

Jun 25 14:50:45: htsp_process_event: [1/0/0, FXOLS_WAIT_RING_MIN, E_HTSP_EVENT_TIMER]fxols_wait_ring_min_timer

Jun 25 14:50:45: htsp_timer - 10000 msec

Jun 25 14:50:46: htsp_process_event: [1/0/0, FXOLS_RINGING, E_DSP_SIG_0100]

Jun 25 14:50:46: fxols_ringing_not

Jun 25 14:50:46: htsp_timer_stop

Jun 25 14:50:46: htsp_timer - 10000 msec

Jun 25 14:50:46: htsp_process_event: [1/0/0, FXOLS_RINGING, E_DSP_SIG_0000]

Jun 25 14:50:47: htsp_process_event: [1/0/0, FXOLS_RINGING, E_DSP_SIG_0100]

Jun 25 14:50:47: fxols_ringing_not

Jun 25 14:50:47: htsp_timer_stop

Jun 25 14:50:47: [1/0/0] htsp_stop_caller_id_rx. message length 0htsp_setup_ind

Jun 25 14:50:47: [1/0/0] get_fxo_caller_id:Caller ID receive failed. parseCallerIDString:no data.

Jun 25 14:50:47: [1/0/0] get_local_station_id calling num=0000000000 calling name=External calling time=06/25 16:50

Jun 25 14:50:47: [1/0/0] htsp_dsm_close_done

Jun 25 14:50:47: htsp_process_event: [1/0/0, FXOLS_WAIT_SETUP_ACK, E_HTSP_SETUP_ACK]

Jun 25 14:50:47: fxols_wait_setup_ack:

Jun 25 14:50:47: htsp_timer - 6000 msec

Jun 25 14:50:47: htsp_process_event: [1/0/0, FXOLS_PROCEEDING, E_HTSP_PROCEEDING]fxols_offhook_prochtsp_alert_notify

Jun 25 14:50:48: htsp_process_event: [1/0/0, FXOLS_PROCEEDING, E_HTSP_ALERT]fxols_offhook_alert

Jun 25 14:50:51: htsp_process_event: [1/0/0, FXOLS_PROCEEDING, E_DSP_SIG_0000]fxols_proceed_ring

Jun 25 14:50:51: htsp_timer_stop

Jun 25 14:50:52: htsp_process_event: [1/0/0, FXOLS_PROCEEDING, E_DSP_SIG_0100]fxols_proceed_clear

Jun 25 14:50:52: htsp_timer_stop2

Jun 25 14:50:52: htsp_timer - 6000 msec

Jun 25 14:50:58: htsp_process_event: [1/0/0, FXOLS_PROCEEDING, E_HTSP_EVENT_TIMER]fxols_disc_confirm

Jun 25 14:50:58: htsp_timer_stop

Jun 25 14:50:58: htsp_timer_stop2

Jun 25 14:50:58: htsp_process_event: [1/0/0, FXOLS_PROCEEDING, E_HTSP_RELEASE_REQ]fxols_offhook_release

Jun 25 14:50:58: htsp_timer_stop

Jun 25 14:50:58: htsp_timer_stop2

Jun 25 14:50:58: [1/0/0] set signal state = 0x4 timestamp = 0

Jun 25 14:50:58: htsp_timer - 2000 msec

Jun 25 14:51:00: htsp_process_event: [1/0/0, FXOLS_GUARD_OUT, E_HTSP_EVENT_TIMER]fxols_guard_out_timeout

Jun 25 14:51:00: htsp_process_event: [1/0/0, FXOLS_ONHOOK, E_DSP_SIG_0100]

Thanks so far.

Cheers,

Michel

Create
Recognize Your Peers
Content for Community-Ad